JWA 68439 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
KOS
ITEM CODE 68439
DESK

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when lifting. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
2
Allow 45 min For 2 person Additional tools required

3
PARTS LIST
1Desktop panel
2Top panel
3Left side panel
4Right side panel
5Middle panel
6Layer panel
7Back panel
P1 Metal frame
P2 Connection pipe
P3 Support pipe
P4 Support pipe
P5 Support pipe

4

Load the fitting F into the metal frame P1.
5
将配件F装入P1金属架；
STEP 1:
Connect connection pipes P2, P4 and P5 with metal frame
P1 with fitting B.
STEP 2:

6
Fix metal pipe P3 to metal pipe P2 and P5 with fitting C and D
respectively.
STEP 3:
Fix panel 1 on the metal assembly with fitting B.
STEP4:

7
Load the fitting E into the matching hole position of panel 1.
STEP 5:
Connect and fix panel 3 and panel 5 at both ends of panel 6
with fittting A.
STEP 6:

8
Fix panel 3, 4 and 5 on panel 1 with fitting A.
STEP 7:
Load into back panel 7.
STEP 8:

9
Use fitting A to fix panel 2 to the matching space of panel 3, 4
and 5 respectively.
STEP 9:
Install an anti-fall device behind the bottom of the desktop.
STEP 10:

10
ASSEMBLY IS COMPLETE