Kanto FMC4 User manual

Supporting your digital lifestyle™
Supplied Parts and Hardware
3
Wall Plate
• 3/16” wood drill bit
• 7/16” masonry bit (for concrete installs)
• Socket set
• Phillips screwdriver
• hammer (for concrete installs)
• carpenter’s level
• stud nder
Required Tools
A: M5 x 15mm
Screw
C: M6 x 15mm
Screw
B: M5 x 25mm
Screw
D: M6 x 25mm
Screw
E: M8 x 15mm
Screw
G: M8 x 35mm
Screw
F: M8 x 25mm
Screw
K: Lag Bolt
M: 5mm Allen Key
N: 6mm Allen Key
L: Concrete Anchor
x4 x4 x4
J: Plastic Spacer
x4 x6
I: Lag Bolt Washer
x6 x6
x4 x4 x4 x4
x4
H: Washer
O: Quick-Lock
Bracket Arm
P: Locking
Bracket Arm

Supporting your digital lifestyle™
7
Step 5: Tilt the TV
Loosen the tilt bolts on both sides of the mount plate using
the 5mm Allen Key (M), as shown in Diagram G. Tilt the TV to
the desired angle and tighten the tilt bolts.
Step 6: Cable Management
Route your TV cables using the wire management
covers installed to the underside of the FMC4 mount
arms, as shown in Diagram H. The wire management
cover is located on the opposite side of the front arm.
You can remove the screws and mount each of the wire
management covers on the opposite side, if desired.
Diagram G
Tilt Bolts
Diagram H