Kargo Master 40640 User manual

Assembly Guide
40640
Kargo Master
Rancho Cordova, CA 95742
800-343-7486
[e-mail]
20200506R3 DATE:_____________

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 1
Installation Guide –40640
Parts
*PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT*
Warning
Always check for wires, fuel tanks and lines, brake lines and other important vehicle
functionality items prior to drilling and installing all products.
Tools Needed
3/8” Wrench and Socket
7/16” Wrench and Socket
Table of Contents
Parts .....................................................................................................................................2
Hardware .............................................................................................................................2
Step 1 –Bolt Together ..........................................................................................................3
Before You Begin
Read all instructions before installing any Kargo Master product.

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 2
Installation Guide –40640
Parts (Continued)
Hardware

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 3
Installation Guide –40640
Step 1 –Bolt Together
Place both partition pieces flat on
the ground or on a table as shown.
Be sure to have the flanges facing
upward so you can access the bolt
holes.
Bolt together using a 1/4" x 5/8”flanged hex bolt and a 1/4” flanged lock nut.
If installing the Center Panel Latch & Door Lock Kit (40620), be sure to bolt two flat
washers in between the two panels at each location. This is used to get correct spacing.
If no door kit is being used, the washers between panels are not needed.

For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST) Page 4
Installation Guide –40640
Repeat 3 more times in the locations as shown below. Be sure to insert the washers
between the panels if the door kit is being installed.
Some like to leave bolts snug tight to allow movement untill partition is installed into
vehicle.
Follow instructions of desired wing kit to install into vehicle.
v
v
v
v