
to take your juicer apart
1 Remove the pulp collector by
pressing the pulp collector catch
and sliding the collector out.
2 Unlatch the lid and lift off.
3 Remove the filter and filter holder
together. Then separate for
cleaning.
care and cleaning
OBefore cleaning, unplug your juicer.
OIf the filter is too tight to remove,
wait a few minutes until it loosens
up.
OSome foods, eg carrot, will
discolour the plastic. Rubbing with
a cloth dipped in vegetable oil
helps remove discolouring.
motor unit
OWipe with a damp cloth, then dry.
ODo not immerse in water.
OStore excess cord in the storage
area at the back of the power
unit .
lter
OClean using the brush supplied.
Note: Use the flat end of the brush
to remove pulp from the lid.
OCheck the lter regularly
for signs of damage. Do not
use if the lter is damaged.
Refer to “service and
customer care”
other parts
OWash in hot soapy water, then dry.
O Alternatively they are dishwasher
safe and can be washed on the
top rack of your dishwasher.
Avoid placing items on the bottom
rack directly over the heating
element. A short low temperature
(Maximum 50°C) programme is
recommended.
service and customer
care
OIf you experience any
problems with the operation
of your appliance, before
requesting assistance refer to
the “troubleshooting guide”
section in the manual or visit
www.kenwoodworld.com.
OPlease note that your product
is covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the country
where the product was purchased.
OIf your Kenwood product
malfunctions or you find any
defects, please send it or bring
it to an authorised KENWOOD
Service Centre. To find up to date
details of your nearest authorised
KENWOOD Service centre visit
www.kenwoodworld.com or the
website specific to your Country.
ODesigned and engineered by
Kenwood in the UK.
OMade in China.
6