KEPCO RTW 100W Series User manual

©2022, KEPCO, INC 1
Data subject to change without notice 228-1947
INSTRUCTION MANUAL
KIT
KEPCO, INC.  131-38 SANFORD AVENUE  FLUSHING, NY. 11355 U.S.A. TEL [phone]FAX [phone]
www.kepcopower.com email: [e-mail]
DIN RTW-100VL
KEPCO An ISO 9001 Company.
DIN-RAIL MOUNTING KIT
FOR SERIES RTW 100W
FIGURE 1. VL SUFFIX ORIENTATION
INSTALLING KIT. Attach the preassembled mounting plate with clips to the power supply using the hardware supplied
(see Figure 3). The plate may be mounted with the release lever on either side to facilitate removal.
INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of the clip under
one edge of the rail, then snap the other end of the clip into place (see Figure 2A).
NOTE:For applications where the installed power supply may be subject to unusual levels of shock or vibration, the
use of two DIN rail end stops (Kepco P/N 108-0367) is recommended. After installing the power supply on the
rail, the end stops are installed by clearing the DIN rail of other components and sliding the end stops over the
rail. When the end stops are secure against the power supply, tighten the two integral screws of each end stop.
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage the clip from the rail.
FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
A - INSTALLATION B - REMOVAL
DESCRIPTION. Kepco Kit, Model DIN RTW-100VL,
contains a preassembled mounting plate and associ-
ated hardware used to install RTW 100 Watt Series
power supplies on a DIN rail. The “VL” suffix is for
mounting vertically, along the long dimension (length)
as shown in Figure 1. Outline dimensions are shown
in Figure 4.
3044607

2228-1947 062922
KEPCO, INC.  131-38 SANFORD AVENUE  FLUSHING, NY. 11355 U.S.A. TEL [phone]FAX [phone]
http://www.kepcopower.com email: [e-mail]
FIGURE 3. INSTALLATION OF KIT ON RTW 100W POWER SUPPLY
FIGURE 4. RTW 100W POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS
C
A
7.677 [195.00]
3.335 [84.71]
4.411
[112.03]
3044610