Kesseböhmer Verso Wall Unit User manual

04.06.2010
KESSEBÖHMER l 1 l 2 l 3
HANDLING INFORMATION
Verso + Strato Wall Unit
Problem Possible cause Possible solution (summary) Detailed advice
1. Unit panel does not stay in position. Spring force too low. Increase/adjust spring force. 1.1
2. Unit panel opens too quickly and
springs upwards. Spring force too high. Reduce spring force. 2.1
3. Unit door is not aligned when closed. Adapter plate setting not appropriate for traction
lever. Adjusting screws need to be adjusted. 3.1
Front panel
attachment
Lifting
arm
Housing
cover
Cushion
Adjustment slide
for adjusting force
Base plate
Base body
Traction
lever
Operating
element
Hydraulic cylinder
(internal)
Adapter plate
with adjusting
screw

KESSEBÖHMER l 1 l 2 l 3
HANDLING INFORMATION
Verso + Strato Wall Unit
1.1 Spring force too low
2.1 Spring force too high
Remove the housing cover. Using a hexagon key (4 mm), increase
the force by turning the key anticlockwise (the adjustment slide
moves down). This adjustment procedure must be performed on
both lifting arms.
Remove the housing cover.
Using a hexagon key (4 mm), reduce the
force by turning the key clockwise (the
adjustment slide moves up). This adjust-
ment procedure must be performed on
both lifting arms.
Do not use a cordless
screwdriver!
Do not use a cordless
screwdriver!
1. Unit panel does not stay in position
2. Unit panel opens too quickly and springs upwards
Strato
Verso
Adjustment slide
moves down.
Adjustment slide
moves up.

KESSEBÖHMER l 1 l 2 l 3
A B
A
B
B
A
➊
HANDLING INFORMATION
Verso + Strato Wall Unit
3.1 The adjusting screw of the adapter plate has not been set correctly
➊ Insert a hexagon key (max. 4 mm) in the adjusting screw.
Adjust the adjusting screws on the left-hand and right-hand fittings
to improve the closing action.
The protrusion issue in figure A can be corrected by means of an
upwards adjustment and the protrusion issue in figure B by means of
a downwards adjustment.
3. Unit door is not aligned when closed
Once the furniture has been installed (or adjustment work has been performed on the front panels), the
front panels may not close cleanly. This could result in the front panels protruding at an angle as shown in
figures A and B.
Left-hand side Right-hand side