Kinderkraft I-BOOST i-Size User manual

MODEL: I-GUARD ECE.R129.03 ver. 1.2
I-BOOST i-Size
USER GUIDE
MODEL: I-BOOST i-Size ECE R129.03 v.1.0

2
NOTE! Product graphics serve an illustrative function!
1.0 Usage
The car seat has been designed, tested and approved for use in
accordance with the requirements of UN/ECE Regulation No. 129
concerning the approval of child restraint systems (UN/ECE R129/03).
The I-BOOST i -Size car seat is intended for for transporting children with
a height between 135-150 cm (up to approximately 12 years). The child
should be fastened using three-point car seat belts for adults.
The car seat can be installed in the car in the places indicated by the
manufacturer in the vehicle manual. It is required to read the vehicle
manufacturer's operating instructions.

3
Hight of the child
Car seat setting
Car seat mounting
135-150cm
ISOFIX + three-point car seat belt
Three-point car seat belt

4
2.0 Safety instructions
Please take a few minutes to read this instruction manual in order to
ensure the proper safety of your child.
• The car seat MUST NOT be installed on the vehicle seats
mounted backwards or sideways.
• The car seat can only be installed on the vehicle seat with
a three-point car seat belt.
• The front air-bag must be deactivated.
• It is recommended to install the car seat on the vehicle
back seats only.

5
Please refer to your vehicle operating manual for information on the
suitability of the vehicle seat for use with a car seat.
• Remember that the internal safety harness holding the child should be
adapted to the child's body shape and not twisted. For this reason, the child
should not wear thick clothes under the safety harness.
• The car seat waist belts must run as low as possible across your child's pelvis
to ensure optimum effect in the event of an accident.
• The car seat should be replaced when it has been subjected to violent
stresses during a traffic accident.
• The car seat may not be modified in any way without the acceptance of the
relevant approval authority. Failure to install the car seat in accordance with
the manufacturer's instructions may pose a threat to life and health.
• Protect the car seat from direct sunlight, otherwise your child may be burnt
by heated parts. Protect your child and the car seat from sunlight.
• Never leave your child unattended in the car seat.
• Make sure that the luggage and other objects are adequately secured,
in particular on the parcel shelf, as they can cause injuries in the event of
a collision.
• The car seat cannot be used without the cover.
• Do not use replacement covers, other than those recommended by the
manufacturer, as the cover is an integral part of the safety system of the
car seat.
• Do not use any other attachment points than those described in the
instruction manual and marked on the car seat.
• All hard elements and plastic parts of the child car seat should be
placed and installed in a way that, under normal vehicle operating
conditions, they cannot get trapped by the sliding seat or vehicle doors.
• Regularly check the technical condition of the car seat, pay special
attention to the fixing points, seams and adjusting elements. It is
important to ensure that all mechanical elements are fully operational.
Never grease or oil parts of the car seat.

6
• Do not use the car seat if its parts are damaged or loose.
• In the event of an emergency, it is important to quickly unfasten the safety
harness. This means that the release button of the safety harness is not fully
secured; make sure your child does not play with the safety harness.
• Set a good example for your child and wear your car seat belt at all times.
An adult who is not fastened with a car seat belt can also pose a threat to a
child.
• Make sure that the car seat is correctly secured before each journey in the
car.
• The car seat must be secured at all times, even when not in use. The car
seat that is not fastened can injure the passengers even during emergency
braking.
• On some vehicle seats made of delicate materials, the use of car seats
may leave marks and/or discolouration. To prevent this from happening,
you can place a blanket, towel or similar product under the car seat.

7
IMPORTANT! Make sure there are no gaps between the car
seat and the vehicle seat.
IMPORTANT! To ensure your child's comfort, move the
front vehicle seat as far forward as possible to provide room
for your child's legs.

8
3.0 ISOFIX installation
1. Place the car seat on the vehicle seat. Press both sides of the ISOFIX
release button and extend the ISOFIX connector arms to their maximum
length.
2. Grasp the car seat with both hands and insert both latches into the
places of installation on the vehicle seat. When you hear a "click" of each
of the ISOFIX latches, push the seat of the car seat against the backrest
of the vehicle seat, exerting firm even pressure on both sides.
NOTE! The locking latches are properly attached only when both button
indicators are completely green.
Pay attention to the audible clicking sound of the ISOFIX
connectors and grasp the car seat to check whether it is
securely installed without any play. If it moves and the ISOFIX
latches come out, repeat the previous steps.

9
4.0 Installation of the car seat
Note! The car seat should be placed directly on the vehicle seat.
4.1 Children between 135 and 150 cm - using
the ISOFIX connectors and a three-point car
seat belt.
1. Install the car seat on the vehicle seat using ISOFIX connectors forward
facing
2. Push the car seat all the way into the seat and check its correct
installation –the colour of the indicators should change to green.
3. Place your child in the car seat
4. Pull the shoulder belt tight and guide it over your child's shoulder
5. Guide the car seat belt through both waist belt guides.
6. Fasten the car seat belt. You will hear a characteristic "click".

10
4.2 Children between 135 and 150 cm tall -
using a three-point car seat belt.
1. Install the car seat forward facing on the vehicle seat.
2. Push the car seat all the way to the vehicle seat.
3. Place your child in the car seat
4. Pull the shoulder belt tight and guide it over your child's shoulder
5. Guide the car seat belt through both waist belt guides.
6. Fasten the car seat belt. You will hear a characteristic "click".

11
5.0 Removing the car seat (ISOFIX installation
system)
1. Press the release button on both ISOFIX latches. (The latches will be
released, and the colour of the ISOFIX indicators will change from green
to red)
2. Insert the ISOFIX arms into the base of the car seat.

12
5.1 Removing the cover
1. Starting at the bottom of the car seat, carefully remove the cover on
both sides of the car seat
2. Pull the fabric off the armrests
3. Remove the fabric completely from the car seat by pulling it towards
you
5.2 Installing the cover
To put the cover back on - just reverse the above sequence of actions.
Align the cover with the attachment points on the car seat. Start by
installing the cover on the shell of the car seat and finally on the
headrest part.

13
6.0 Cleaning
NOTE! The car seat must not be used without the cover.
• The cover is removable and washable with a mild powder and using a
program for delicate fabrics (30°C).
•Follow the washing instructions on the cover information label. The colours
may fade if it is washed at the temperature above 30°C. The cover should not
be centrifuged or dried in a tumble dryer (which may lead to separation of the
material layers).
• Prolonged sun exposure of the cover is prohibited.
• Plastic parts can be cleaned with soap and water.
• Do not use aggressive cleaning agents (such as solvents).
• The safety harness can be cleaned in lukewarm soapy water.
Warning! You must not remove the metal clips from the safety harness.
The full text of the Warranty Terms and Conditions is available on the
website WWW.KINDERKRAFT.COM

14