KitchenAid KSMMGA User manual

KSMMGA
W11204951A_ENv07.indd 1 3/2/18 4:45 PM

PARTS AND FEATURES
PARTS AND ACCESSORIES
Food pusher
Blade
Fine grinding
plate (3 mm)
Sausage
stuffer plate
Coarse
grinding plate
(8 mm)
CollarMedium
grinding plate
(4.5 mm)
Main housing
Grind screw
Removable tray
Cleaning brush
Small sausage stuffer
tube (9.5 mm)
Large sausage stuffer
tube (19 mm)
W11204951A_ENv07.indd 2 3/2/18 4:45 PM

ENGLISH
METAL FOOD GRINDER ATTACHMENT SAFETY | 3
METAL FOOD GRINDER ATTACHMENT SAFETY
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always
be followed, including the following:
1. Read all instructions.
2. This appliance is not intended for use by persons (including children) with
reduced physical, sensory, or mental capabilities, or lack of experience or
knowledge, unless they are closely supervised and instructed concerning use
of the appliance by a person responsible for their safety. Close supervision is
necessary when any appliance is used by or near children. Children should be
supervised to ensure that they do not play with the appliance.
3. Turn the Stand Mixer OFF (and detach the Metal Food Grinder attachment from
the Stand Mixer) after each use of the attachment and before cleaning. Make
sure motor stops completely before disassembling.
4. Avoid contacting moving parts. Keep ngers out of discharge opening.
5. The use of attachments not recommended or sold by KitchenAid may cause
re, electric shock, or injury.
6. Never feed food by hand. Always use the food pusher.
7. Blades are sharp. Handle carefully.
W11204951A_ENv07.indd 3 3/2/18 4:45 PM

4| USING THE METAL FOOD GRINDER ATTACHMENT
METAL FOOD GRINDER ATTACHMENT SAFETY
USING THE METAL FOOD GRINDER ATTACHMENT
GUIDE TO GRINDING
8. Do not use ngers to scrape food away from discharge disc while appliance is
operating. Cut-type injury may result.
9. Also see the Important Safeguards section included in the Stand Mixer Use
and Care guide.
SAVE THESE INSTRUCTIONS
This product is designed for household use only.
NOTE: None of the parts and accessories of this KitchenAid®Metal Food Grinder attachment
(model KSMMGA) are compatible with the parts and accessories of the KitchenAid®Food
Grinder attachment (models FGA, SSA, FT, FVSP, FVSFGA, KSMFPPA, KSMGSSA) and vice
versa.
USE THESE PARTS WITH THESE
PARTS
SUGGESTED
USES SPEED
Fine grinding plate
(3 mm) Blade Cooked meats for spreads, hard
cheeses (e.g. Parmesan), bread
crumbs 4
Medium grinding plate
(4.5 mm) Blade Raw or cooked meats, meats for
sausages 4
Coarse grinding plate
(8 mm) Blade Raw meats for burgers and chili,
vegetables for salsas and sauces 4
Small sausage stuffer
tube (9.5 mm) Sausage stuffer plate Breakfast sausage, smaller sausages 4
Large sausage stuffer
tube (19 mm) Sausage stuffer plate Bratwurst, larger sausages 4
W11204951A_ENv07.indd 4 3/2/18 4:45 PM

ENGLISH
USING THE METAL FOOD GRINDER ATTACHMENT | 5
USING THE METAL FOOD GRINDER ATTACHMENT
ASSEMBLING THE METAL FOOD GRINDER ATTACHMENT
1
Insert the grind screw into the main housing. Then,
place the blade over the end of the grind screw.
The blade should t entirely inside the housing. If it
doesn’t, pull it off, turn it over, and place it again.
2 Place grinding plate over the blade, matching the
notch of the plate with the tab on the bottom of the
main housing.
3 Place the collar on the main housing, turning clockwise
by hand until secured but not tightened.
Wash all parts with warm, soapy water and dry thoroughly before use.
ATTACHING THE METAL FOOD GRINDER ATTACHMENT TO THE
STAND MIXER
1 Turn the Stand Mixer off and unplug.
2
For Stand Mixers with a hinged attachment hub
cover: Flip up to open.
For Stand Mixers with a removable attachment hub
cover: Turn the attachment knob counterclockwise to
remove attachment hub cover.
3
Insert the attachment shaft housing into the
attachment hub, making certain the power shaft ts
into the square hub socket. If necessary, rotate the
attachment back and forth. The pin on the attachment
housing will t into the notch of the hub rim when in
the proper position.
Tab
Notch
W11204951A_ENv07.indd 5 3/2/18 4:45 PM

6| USING THE METAL FOOD GRINDER ATTACHMENT
USING THE METAL FOOD GRINDER ATTACHMENT
GRINDING WITH THEMETAL FOOD GRINDER ATTACHMENT
4 Tighten the Stand Mixer attachment hub knob
clockwise until the attachment is completely
secured to the Stand Mixer.
1 Cut food into small strips or pieces sized to t into the
feed tube.
WARNING
Rotating Blade Hazard
Always use food pusher.
Keep fingers out of openings.
Keep away from children.
Failure to do so can result in amputation or cuts.
2 Turn the Stand Mixer to Speed 4 and feed food into
the feed tube using the food pusher.
W11204951A_ENv07.indd 6 3/2/18 4:45 PM

ENGLISH
USING THE METAL FOOD GRINDER ATTACHMENT | 7
USING THE METAL FOOD GRINDER ATTACHMENT
ASSEMBLING THE SAUSAGE STUFFER
USING THE SAUSAGE STUFFER
1
Insert the grind screw into the main housing. Then
insert the sausage stuffer plate over the end of the
grind screw, matching the notch of the plate with the
tab on the bottom of the main housing.
2
Insert the desired sausage stuffer tube (large or small)
through the collar. Then, place the collar and tube
assembly on the main housing, turning the ring by
hand until secured but not tightened.
Tab Notch
1 Feed meat into the Metal Food Grinder attachment
before adding the sausage stuffer tube. This will
eliminate air pockets.
2 Lubricate the sausage stuffer tube and slide one casing
over the tube, leaving about four inches to tie off the
end.
3
Turn the Stand Mixer on to Speed 4 and slowly push
the meat through the grinder. Hold the casing rmly as
it lls. If air bubbles are created during the ll process,
use a pin or needle to pop the bubble.
4 Run meat through until 4-6 inches of casing is left
unlled. Turn off the Stand Mixer and tie the remaining
end of the casing, or use a tie string.
NOTE: For segmented-type sausage (e.g., bratwurst), twist casing ends in alternating
directions at desired sausage link length.
W11204951A_ENv07.indd 7 3/2/18 4:45 PM

8| CARE AND CLEANING
TIPS FOR GREAT RESULTS
CARE AND CLEANING
HELPFUL HINTS
CLEANING THE METAL FOOD GRINDER ATTACHMENT AND
ACCESSORIES
For best results, grind meat that is very cold
or partially frozen. The grinder parts can
be pre-chilled in the refrigerator or freezer
before use to maintain a cold grinding
temperature.
For more tender results, some meats can be
ground twice. However, fatty meats should be
ground only once.
To grind bread for crumbs, be sure that bread
is either oven-dried thoroughly to remove all
moisture, or not dried at all. Partially dried
bread may jam the Metal Food Grinder
attachment.
NOTE: Very hard, dense foods such as
completely dried homemade bread should
not be ground in the Metal Food Grinder
attachment. Homemade bread should be
ground fresh and then oven- or air-dried.
If using natural casings, it is recommended to
rst soak them in cold water for 30 minutes
to remove excess salt, then rinse several
times by running cold water through the
entire length of the casing. For best results
for sausage, refer also to the instructions that
came with the casings.
FOR DETAILED INFORMATION ON USING THE METAL FOOD GRINDER ATTACHMENT
Visit kitchenaid.com/quickstart for additional instructions with videos, inspiring recipes, and
tips on how to use your Food Grinder attachment.
1 Use the cleaning brush to clean the main housing and
other accessories, including the grinding plates.
2 The following parts are dishwasher-safe, top rack only:
sausage stuffer plate, sausage stuffer tubes, cleaning
brush, and food pusher.
3
The following parts should be hand-washed only,
using warm, soapy water and drying thoroughly:
main housing, grind screw, collar, tray, grinding
plates, and blade.
FOR DETAILED INFORMATION ON USING THE METAL FOOD GRINDER ATTACHMENT
Visit kitchenaid.com/quickstart for additional instructions with videos, inspiring recipes, and
tips on how to use your Food Grinder attachment.
W11204951A_ENv07.indd 8 3/2/18 4:45 PM

ENGLISH
WARRANTY AND SERVICE | 9
WARRANTY AND SERVICE
KITCHENAID METAL FOOD GRINDER ATTACHMENT WARRANTY
FOR THE 50 UNITED STATES, THE DISTRICT OF COLUMBIA, PUERTO
RICO, AND CANADA
This warranty extends to the purchaser and any succeeding owner for Metal Food Grinder
attachments operated in the 50 United States, the District of Columbia, Puerto Rico, and Canada.
Length of Warranty: One Year Full Warranty from date of purchase.
KitchenAid Will Pay
for Your Choice of: Hassle-Free Replacement of your Metal Food Grinder
attachment. See the next page for details on how to arrange
for service, or call the Customer eXperience Center toll-free at
1-800-541-6390.
OR
The replacement parts and repair labor costs to correct defects
in materials and workmanship. Service must be provided by an
Authorized KitchenAid Service Center.
KitchenAid Will
Not Pay for: A. Repairs when your Metal Food Grinder attachment is used
in other than normal single family home use.
B. Damage resulting from accident, alteration, misuse or
abuse.
C. Any shipping or handling costs to deliver your Metal
Food Grinder attachment to an Authorized Service Center.
D. Replacement parts or repair labor costs for Metal Food
Grinder attachments operated outside the 50 United States,
District of Columbia, Puerto Rico, and Canada.
DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES
IMPLIED WARRANTIES, INCLUDING TO THE EXTENT APPLICABLE WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXCLUDED
TO THE EXTENT LEGALLY PERMISSIBLE. ANY IMPLIED WARRANTIES THAT MAY
BE IMPOSED BY LAW ARE LIMITED TO ONE YEAR, OR THE SHORTEST PERIOD
ALLOWED BY LAW. SOME STATES AND PROVINCES DO NOT ALLOW LIMITATIONS
OR EXCLUSIONS ON HOW LONG AN IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY
TO YOU.
IF THIS PRODUCT FAILS TO WORK AS WARRANTED, CUSTOMER’S SOLE AND
EXCLUSIVE REMEDY SHALL BE REPAIR OR REPLACEMENT ACCORDING TO THE
TERMS OF THIS LIMITED WARRANTY. KITCHENAID AND KITCHENAID CANADA
DO NOT ASSUME ANY RESPONSIBILITY FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES. This warranty gives you specic legal rights and you may also have other
rights which vary from state to state or province to province.
W11204951A_ENv07.indd 9 3/2/18 4:45 PM