KMC Controls CEE-3009 User manual

Installation Guide
Fan Speed Controllers
CEE-3009, 3010
Mounting
1. Install a 2" x 4" metal or plastic enclosure mounted near the fan unit.
2. Install the controller in the box using the provided hardware.
3. Check that air moves freely over the heat sink faceplate.
Wiring
The CEE-3009 and 3010 are designed to work with a
CSE-1002 Static Pressure Controller. The CEE-3010
uses 0 to 10 VDC input from a KMC Digital
Controller.
1. Complete connections per the wiring diagram(s).
2. Branch circuit protection (fuses or circuit
breakers) is required.
a. Voltage equal to or greater than the drive’s.
b. Current equal to or less than four (4) times the
drive’s full load rating.
3. Grounding is through the mounting screws to the
grounded enclosure.
CEE 3009 with CSE-1002 Static Pressure Controller CEE-3010

Adjustments and Calibration
Access the speed adjustment potentiometer
through the side opening.
To set the minimum speed:
1. Set the input (the controller’s output) to 1 VDC or
disconnect the input.
2. The fan speed controller output must be wired in
series with the fan motor with power applied.
3. Adjust the potentiometer to the desired minimum
speed.
CAUTION!
The fan speed controller will allow the fan motor to
stall. Maximum current occurs at less than full fan
speed. Do not set the minimum speed at less than
1/2 full synchronous speed. Do not exceed the given
current rating at any speed.
Maintenance
No routine maintenance is required. Each
component is designed for dependable, long term
reliability and performance.
Careful installation will also ensure long term
reliability and performance.
KMC Controls
P.O. Box 497
19476 Industrial Drive
New Paris, IN 46553
U.S.A.
TEL: [phone]
FAX: [phone]
E-mail: [email protected]
899-019-01C
CEE-3009 Shown