Kogan KA21CBDISPA User manual

2-IN-1 COMMERICAL ICE CUBE
MAKER AND WATER DISPENSER
KA21CBDISPA

When using electrical appliances, basic safety precautions should be followed to reduce the
risk of fire, electric shock, and injury to persons or property. Read and understand all
instructions before using the appliance.
•Do not operate this or any other appliance with a damaged cord. Connect to
properly polarised outlets only. No other appliance should be plugged into the
same outlet. Be sure that the plug is fully inserted into the receptacle.
•Do not run the power cord over carpeting or other heat insulating surfaces. Do not
cover the cord. Keep the cord away from traffic areas, and do not submerge in
water.
•The use of an extension cord is not recommended, as it may overheat and present
a risk of fire.
•Unplug the icemaker before cleaning or maintenance is carried out.
•Exercise caution and use reasonable supervision when the appliance is used near
children.
•Do not use the icemaker outdoors. Place the icemaker away from direct sunlight
and make sure that there is at least 4 inches of space between the back of the unit
and the closest wall. Keep a minimum distance of 4 inches free on each side of the
unit.
•Do not use any liquid to make ice other than water.
•Do not clean the ice maker with flammable fluids, as the fumes can create a fire
hazard or explosion.
•Do not tip the unit over. If the icemaker is brought in from outside in winter, allow a
few hours for it to warm up to room temperature before plugging it in.
•If the supply cord is damaged, it must be replaced by Kogan.com or its service
agent to avoid a hazard.
oThis ice maker must be positioned so that the plug is easily accessible.
oDisconnect the mains plug from the supply socket when not in use, where
supply connection is via mains plug.
SAFETY & WARNINGS

•Do not store explosive substances such as aerosol cans with a flammable
propellant in this appliance.
•This appliance is intended to be used in household and similar applications such as
oStaff kitchen areas in shops, offices, and other working environments,
oFarmhouses and by clients in hotels, motels, and other residential
type environments,
oBed and breakfast type environments,
oCatering and similar non-retail applications.
•To avoid hazards due to instability of the appliance, it must always be placed on
an even, stable, and flat surface.
WARNING: This appliance must be earthed.
WARNING:
•Risk of fire/flammable materials used. According to local
regulations regarding disposal of the appliance for its flammable
blowing gas.
•Keep ventilation openings, in the appliance enclosure or the built-
in structure, clear of obstruction.
•Do not damage the refrigerant circuit.
•Do not use mechanical devices or other means to accelerate the
defrosting process or ice harvesting process, other than those
recommended by Kogan.com.
•Do not use another type of electrical appliances inside the
icemaker.

OVERVIEW
Air outlet
Cold water tap
(press button on top to pop out)
Water drain cap
Smart core
(water bottle receptacle)
Cold water tap button
Operation panel
Ice cube basket
(can be pulled out)
Water dispensing button
Ice indicator
Large ice cube indicator
Medium ice cube indicator
Small ice cube indicator
Select button
On/Off button
(selects ice cube size)
Power indicator
Add Water indicator
(signifies no water)
(signifies ice tray full)

Unpacking the appliance
1. Remove the exterior and interior packaging. Check that ice scoop is included. If
any parts are missing, please contact Kogan.com.
2. Clean the interior with lukewarm water and a soft cloth. Take out the ice basket
and clean it.
3. Find a location for the ice maker that is protected from direct sunlight and other
sources of heat (i.e.: stoves, furnaces, and radiators). Place the icemaker on a level
surface. Make sure that there is at least 4 inches of space between the back and
sides of the icemaker and the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging the icemaker in.
5. The appliance must be positioned so that the plug is easily accessible.
6. Before placing water bottle on the unit, be sure that the drain plug on the back is
tightly fastened.
7. Hold the water bottle vertically and upside down (over the unit) and place the
water bottle into the smart core receptacle. Apply slightly pressure to pierce the
bottle cap with the spigot. This unit accepts two, three or five-gallon water bottles
with pierceable sealed caps.
OPERATION

Connecting the appliance
Making ice cubes
1. Press On/Off on the control panel to begin the ice making cycle.
2. Select the size of the ice cube by pressing the Select button.
3. The ice making cycle lasts 6 to 15 minutes, depending on the size of the ice cube
selected and the ambient temperature. During extreme temperatures, the
operational time will differ significantly.
4. If the water pump cannot inject water, the ice maker will stop automatically, and
the Add Water indicator will illuminate on the operation panel. Check the water
bottle and replace with a new bottle full of water as required.
5. Press On/Off button again to start the unit again.
DANGER
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, discontinue use and contact Kogan.com.
1. This unit should be properly grounded for user safety. The power cord of
this appliance is equipped with a three-prong plug which mates with
standard three-prong wall outlets to minimize the possibility of electric
shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall
outlet. Do not, under any circumstances, cut or remove the third (ground)
prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician.
3. This appliance requires a standard 220~240 volt, 50Hz electrical outlet
with a three-prong ground.

6. If a new bottle full of water is inserted, but the Add Water indicator is still
illuminated and the water pump is not working properly, check the two water
filters:
A. The first water filter is in the bottom of the water tank; ensure it is clean and
unobstructed.
B. The secondary water filter is displayed in the image on the next page. Release
the clipper and the water pipe, then take out the water filter and clean it.
Reinstall the water filter and use the clipper to fasten the water pipe again.
Allow the refrigerant liquid inside the compressor to settle for at least 3 minutes before
restarting.
7. The icemaker automatically stops working when the Ice indicator on the operation
panel is illuminated, signifying that the ice basket is full.
Top Cover
Clipper
Water filter
Water Pipe

Pouring cold water
The water poured from the unit will only be cold after the icemaking process has operated
for 30mins or more.
1. Press the button near the operation panel to pop out the cold-water tap.
2. Press the Water Dispensing Button on the operation panel to dispense cold water
from the tap. Release the button when the receptacle has been filled.
Push this button to pop
out the cold-water tap.

Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Use the water to rinse the interior parts and drain out the water by unplugging the
drain cap on the side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent
solution and warm water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use, open the water drain cap to drain the water
completely from the water reservoir.
Description
Ice maker using bottled water, with cold water dispensing
function
Protection Type
I
Climate Type
SN/N/ST/T
Power Rating
220-240V/50Hz
Ice-making Rated Current
1.1A
Ice-harvest Rated Current
1.3A
Refrigerant
R290 / 33g
Vesicant
C5H10
Enclosure
Stainless steel
Dimension
357mm (W) x 423mm (D) x 452mm (H)
Net Weight
15Kg
CLEANING & CARE
SPECIFICATIONS

PROBLEM
POSSIBLE CAUSE
SOLUTION
Add Water indicator is
illuminated.
Lack of water.
Stop the ice maker, replace with a
new bottle full of water, and then
restart it.
One of the water filters is
blocked.
Check both water filters for
obstruction and clean them.
Ice indicator is
illuminated.
The ice basket has filled with
ice-cubes.
Remove and empty the ice basket.
Ice cubes stick
together.
The ice cycle has been
operating for too long.
Stop the ice maker and restart it
when the ice blocks melt. Select
the small ice button.
Water temperature in the
inner tank is too low.
Change the water in the inner tank.
The optimal temperature of the
water is between 8-32°C.
Ice making cycle
appears normal, but
no ice is made.
Ambient temperature or water
temperature in the inner tank
is too high.
Run the ice maker in environments
below 32°C. Pour colder water into
the tank.
Refrigerant liquid leakage.
Contact Kogan.com
Pipe in the cooling system is
blocked.
Contact Kogan.com
TROUBLESHOOTING

Need more information?
We hope that this user guide
has given you the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com