Kohler AWAKEN R99969T User manual

1234175-2A-C 1
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Observe local plumbing codes.
2. The highest working pressure for handspray is 0.5MPa(5 bar). If it exceeds 0.5MPa(5 bar), a pressure reducer is
needed. The highest water and environment temperature is 60°C. Please keep handspray, showerhead and the
shower arm away from heater, or it may become damaged and cause injury to the user.
1234175-2A-C 4
INSTALLATION INSTRUCTIONS
R99969T Multi Function Hand Shower With Slide Bar
AWAKEN
R99969T Multi Function Hand Shower With Slide Bar
AWAKEN
ROUGH-IN DIMENSIONS
SERVICE PARTS
**Color code must be specified when ordering.
685 580
50.4
558
602
Ø116
249
G1/2˝
258
G1/2˝
G1/2˝
1500
831727**
1385142**
1392092**
1061576
1187786**
1190006**
1190000**
1190001**
1190001**
1061576
1190000**
1190006**
79680
77420
880010

1234175-2A-C 2 1234175-2A-C 3
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
INSTALLATION
How to Install the Hand Shower And Hose
Flush both water supply for about one minute before the hand shower(8) is
installed.
Install check valve(9) into the shower inlet if needed. Put the screen washer(10)
into the shower hose(11) connector. Attach the hand shower to shower hose.
Note: Don’t over tighten.
Connect another end of shower hose to the water supply.
Hang the hand shower on the bracket.
How to Install the Slide Bar
Decide on a suitable position for the slide bar avoiding buried cables and pipes
in the wall.
Drill two holes at the proper height in the wall as the bracket(1,8) dimensions.
Put anchors(2) into the holes. Install the bracket(1) with screws(3) in the wall.
Rehearse the slide bar(4), screws(5) and bracket(8). Mark the outline of the
bracket with a pencil on the wall, and find the position of the holes. Drill two
holes and put anchors(2) into the holes. Install the bracket(8) with screws(3) in
the wall.
Slide the handspray holder(9) onto the bar(4). Adjust the holder to the proper
position. Tighten the slide bar kit with screws(5).
Slide the bracket covers(6) onto the slide bar, and install the covers(7).
2
13
5
43.6
22
21.3
21.7
10.8
Bracket Dimensions
2
8
3
5
7
7
6
6
4
4
9
8
9
10
11
How to Operate the Hand
Shower
Rotate the knob of the hand shower to
change the water flow.
How to Maintain the Hand Shower
Any debris or mineral build-up may cause the flow stream to become
distorted or reduce the flow rate. To remove the debris or mineral
build-up, run water through the hand shower, firmly press or rub your
finger back and forth across the rubber nozzles.
Remove and clean the screen washer.