Kohler Memoirs 6' Bubble Massage K-1418-G User manual

Features
•
Acrylic
•
1 hp blower motor with 300 W heater, and electronic
back-lit user control
•
UL listed
•
122 BubbleMassage TM airjets
•
With Zones of Control TM feature
•
72 ″ (182.9 cm) x 42 ″ (106.7) x 22 ″ (55.9 cm)
Codes/Standards Applicable
Specified model meets or exceeds the following:
•
ANSI Z124.1
•
IAPMO/UPC IGC 171
•
Underwriter’s Laboratories (UL)
•
CSA International
BATH WITH AIRJETS
K-1418-G
ALSO K-1418-GCR
Colors/Finishes
•0: White
•Other: Refer to Price Book for additional colors/finishes
Accessories:
•CP: Polished Chrome
•PB: Polished Brass
•Other: Refer to Price Book for additional colors/finishes
Specified Model
Model Description Colors/Finishes
K-1418-G BubbleMassage Bath ❑0 White ❑Other_____
K-1418-GCR BubbleMassage Bath with chromatherapy ❑0 White ❑Other_____
Recommended Accessories
K-7161-AF Drain ❑CP ❑PB ❑Other_____
Optional Accessories
K-1705 Remote control N/A
K-1601 Footstop ❑0 White ❑Other_____
K-1491 Pillow ❑0 White ❑Other_____
K-9498 3″(7.6 cm) whirlpool keypad trim ❑CP ❑PB ❑Other_____
Product Specification:
The BubbleMassage bath shall be 72″(182.9 cm) in length, 42″(106.7 cm) in width, and 22″(55.9 cm) in height. Bath shall be
made of acrylic. Bath shall havea1hpblower motor and back-lit user control. Bath shall have zones of control and 122
BubbleMassage airjets. Bath shall be UL listed. Bath shall be Kohler Model K-1418-G___-_______.
MEMOIRS
®
6’ BUBBLEMASSAGETM
Page1of2
1035475-4-DUSA: 1-800-4-KOHLER
Canada: 1-800-964-5590
kohler.com

Technical Information
Fixture:* basin area top area weight
Bathing
well 48″(121.9 cm) x27″(68.6 cm) 60″(152.4 cm) x30″(76.2 cm) 150 lbs (68 kg)
water depth capacity
To
overflow 16″(40.6 cm) 94 gal. (355.8 L)
* Approximate measurements for comparison only.
Blower
motor /
control:
Heater Voltage Frequency Amperage
1 Hp 300 W 220-240 V 50/60 Hz 3 A
Drop-in cut-out 70-1/2″(179.1 cm) x
40-1/2″(102.9 cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage
Circuit-Breaker (ELCB):
Blower motor/control 220-240 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under bath must provide for a minimum of 1600
lbs. (725.7 kg).
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
This bath is designed for drop-in installation only. It is not
suited for use in a three wall alcove with an overhead shower.
A blower motor/control access panel is required.
42" (106.7 cm)
72" (182.9 cm)
K-1418-GCR
3" (7.6 cm)
1-1/2" O.D.
Blower Motor/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
20-1/8"
(51.1 cm)
22"
(55.9 cm)
5-1/4" (13.3 cm)
36" (91.4 cm)
11-3/4"
(29.8 cm)
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
1-1/16" (2.7 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Product Diagram
MEMOIRS
®
6’ BUBBLEMASSAGETM
MEMOIRS
®
6’ BUBBLEMASSAGETM BATH WITH AIRJETS
Page2of2
1035475-4-D