Kohler 45432IN User manual

45432IN GRID DRAIN WITH OVERFLOW
BEFORE YOU BEGIN
ROUGH-IN DIMENSIONS
All information is based on the latest product information available at the time of publication.
kohler Co. reserves the right to make changes in product characteristics, packaging, or
availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTE:
Observe all local plumbing and building codes.
45433IN GRID DRAIN WITHOUT OVERFLOW
1174812IN Rev-00
45432IN 45433IN
54
41.4
83mm-97.5mm
66
G1 1/4"
41.4
54
G1 1/4"
66
85mm-97.5mm
1
Kohler India Corporation Pvt. Ltd.
6th Floor, Office Block
Ambiance Mall, Ambi Island, NH-8
Gurgaon-122002
Haryana, India
Customer Care No : 1800 103 2244 (Toll Free) & [phone] / 86
Customer Care Email : [e-mail]
www.kohler.co.in
INSTALLATION INSTRUCTIONS

1025650
(SEAL-DRAIN)
1025678
(WASHER-FRICTION)
1180876
TOP BODY
(WITH DRAIN HOLE)
1185437
(BASE-NUT)
1032256
(TRIM RING-DRAIN)
1180877
TOP BODY
(WITHOUT DRAIN HOLE)
1174812IN Rev-001174812IN Rev-00
1. Unscrew the drain flange(1) from drain.
2. Apply plumber’s putty underside of flange as shown.
3. Insert the drain body (2) into the under side
of the lavatory.
4. Thread the drain flange onto the drain body.
5. Tighten the locknut(3) by hand from under-
side of the fixture. Remove any excess putty.
Notes: Do not reposition the drain after the locknut is
tighten, or you may leak the putty seal.
Apply plumber's putty
3
2
1
All Finishes: Clean the finish with a mild soap and warm water. wipe entire surface completely with a clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc., which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler drains and fittings.
CLEANING INSTRUCTIONS
45432IN GRID DRAIN WITH OVERFLOW
45433IN GRID DRAIN WITHOUT OVERFLOW
SERVICE PARTS
INSTALLATION
2 3