Kohler K-258 User manual

         

   
 
   
Fig. #1
1. Refer to Fig. #1.Ifreplacingceramictrim, loosensetscrew
and pull handle off stem extension.
2. Remove stem extension. Insert wide-bladed screwdriver
into slot on bonnet nutand turn counterclockwiseto loosen.
Remove bonnet nut; remove ceramic bell.
3. For new and replacement installations, place new ceramic
belloverbonnet;securewithbonnetnut.Insertwide-bladed
screwdriver into slot on bonnet nut and turn clockwise to
tighten.
4. Placeceramiccapintoovalhandle;securefromunderneath
with flathead screw.
5. Alignhandleassemblyontostemextension;securewithset
screw.
           
     
     
    
   
    
   
Fig. #2
1. Referto Fig. #2.Ifreplacingceramictrim,loosensetscrewand
pull handle off stem extension.
2. Removestemextension.Insertwide-bladedscrewdriver
into slot on bonnet nut and turn counterclockwise to
loosen. Remove bonnet nut; remove ceramic bell.
3. For new and replacement installations, place new
ceramic bell over bonnet; secure with bonnet nut. Insert
wide-bladed screwdriver into slot on bonnet nut and turn
clockwise to tighten.
4. Place ceramic cap into oval handle; secure from
underneath with flathead screw.
5. Align handle assembly onto stemextension; securewith
set screw.
                 
      
     
Fig. #3
      
1. Referto Fig.#3.Ifreplacingceramictrim,loosensetscrew
and pull handle off stem extension.
2. Loosen oval-head screw and remove bonnet, washer and
spring. Loosen dog-point screws and remove mounting
plate. Remove ceramic ring.
3. For new and replacement installations, place ceramic ring
over valve. Secure with mounting plate and two dog-point
screws.
4. Placespring,washer,andbonnetovervalveasshown.Se-
cure bonnet onto valve with oval-head screw.
5. Place ceramic cap into oval handle; secure from
underneath with flathead screw.
6. Align and place handle assembly onto bonnet; secure with
set screw.
                  
      
     


Fig. #4
   
    
1. Refer to Fig. #4.Ifreplacing ceramictrim, loosensetscrew
and pull handle off bonnet.
2. For new and replacement installations, place ceramic cap
into oval handle; secure from underneath with flathead
screw.
3. Align and place handle assembly onto bonnet; secure with
set screw.
       
    
     
 
     
      
   
        
          
   




