Kohler sprig User manual

1486211-2-B©2022 Kohler Co.
INSTALLATION INSTRUCTIONS
CAUTION: Risk of personal injury. Verify that
the shower arm is adequately supported before
installing the infusion device.
Cover the drain with a towel to avoid losing small
parts.
Follow all local plumbing and building codes.
2
1
□Using an adjustable wrench, remove the
showerhead.
□Wrap the provided sealant tape around the shower
arm threads twice clockwise.
□Verify the orientation of the Sprig adapter piece
(shown) and tighten using the provided wrench.
3
4
5
□Push the infusion device fully onto the adapter.
□Tighten the setscrews.
□Wrap the provided sealant tape around threads
twice clockwise.
□Reinstall the showerhead.
□Turn ON the water and check for leaks.

1486211-2-BKohler Co. 1486211-2
STEPINTOSPRIG.COM
MAINTENANCE
□Periodically rinse the top of the infusion device with
water to remove any excess blend.
□Activate the infusion device without an infusion pod
installed to flush the system.
TROUBLESHOOTING
The existing showerhead is difficult to remove.
1. Use a suitable wrench or a dry towel to grip the
showerhead and remove.
The infusion device is leaking.
1. Remove the sealant tape and reapply.
2. Verify that the adapter is tightened.
3. Verify that the infusion device is fully pushed onto
the adapter piece.
Need Help?
Email us at [email protected] OR
Give us a call at 844-417-7744 (844-41-SPRIG)
Sprig by KOHLER
444 Highland Dr, MS 083
Kohler, WI 53044
Service
For service parts, visit stepintosprig.com/service
Cleaning
For care and cleaning, visit stepintosprig.com/care
Warranty
This product is covered under the Sprig by
KOHLER®Lifetime Limited Warranty, found at
stepintosprig.com/warranty. For a hardcopy of
warranty terms, please contact the Customer Care
Center.
Activate the experience
NOTE: The pod can be activated anytime during the
shower experience.
□Turn ON the water at the desired temperature.
□Press down on the button once to activate the pod.
Release, reseal, reuse
NOTE: Reseal unfinished pods to keep the blend fresh
for the next use.
□Rotate the pod counter-clockwise to release.
□Press the top of the pod until the pod clicks to reseal.
□Remove and reuse multisession pods.
3
4
5
Recycle
NOTE: A small amount of blend may be left in an empty
pod. The pod can still be recycled.
□Visit stepintosprig.com/recycle for most up-to-date
guidelines.
□Follow all local recycling protocols.
INSTALLING THE INFUSION POD
1
2
Select an infusion pod
□Select the desired blend.
Install the infusion pod
□Align the lines of the pod and the infusion device.
□Find the groove, and rotate the pod clockwise until
the pod locks into place and the top of the pod
pops open.
NOTE: It is normal for water to drain from the back of
the infusion device as pressure releases.
NOTE: The infusion time lasts between 1-1/2 and 2
minutes. The aromatherapy of the infusion can last
beyond the shower experience.
NOTE: The blend is safe for hair and face application.