- 7 -
Installing / removing brush heads
Turn the brush head clockwise and remove it upwards.
To install the brush head , apply the opposite procedure.
The brush head must click in on installation. Only use original brush
heads, to avoid damage to the appliance. (For replacement brush heads,
see the order form)
First use
Before operating the appliance, ensure that it is in working condition. If
not, it may not be used.
• Insert the power cord into the wall socket.
• Before the first use, clean the new brush heads with clear water.
• Place the hand appliance into the charging station such that it
easily slides into the guides in the plinth.
• Allow the hand appliance to charge up for ca. 24 hours before
using it for the first time. After the first use, the battery requires only
approximately 12 hours to completely recharge. The display light
on the front of the hand appliance glows red during the charging
process.
Notice: If the hand appliance is fully charged, remove the plug of the
charging station from the mains power socket. This contributes to the
care of the batteries if you place the hand appliance back into the
charging station after every use. Insert the plug into the mains power
socket to recharge the hand appliance first when the movements of the
toothbrush have noticeably weakened.
