kozy heat NK41-500 User manual

#NK41-500 LOG SET
For use with model #NDK-41-DV
WARNING: This product can expose you to chemicals including ceramic ber and/or silica dust which is (are) known to the State of California
to cause cancer, birth defects, or other reproducve harm. For more informaon, visit www.P65Warnings.ca.gov
• If converng to propane, complete the con-
version before installing the log set. Follow
the conversion instrucons included with
the kit.
• If installing a panel set, complete installa-
on of panel set before log installaon
• Install all light bulbs into the front and rear
ember bed light kits before log installaon.
1. Remove valance from replace. Remove the
(4) screws securing the log rack / emberbed
panel.
2. Remove the le and right burner assembly
by loosening the 7/16” nut that secures
each burner assembly down to the control
board. Slide each burner to the side of the
replace to remove. Note: it may be easier
to remove the light kit assembly to access
the 7/16” nuts securing the burner assem-
blies.
3. Place log #N41-1 and log #N41-2 on corre-
sponding pins on burner (not shown). Logs
must lie at on media tray. Failure to do so
will negavely aect the ame
4. Place log #N41-3 on the corresponding pin
on top of #N41-2. Rotate the opposite end
of #N41-3 towards the back of the replace.
5. Fill back media tray with crushed glass
media.
6. Place log #N41-6 on top of the crushed
media as shown.
7. Place the klinkers on the rear burner as
shown here. There are (2) smaller klinkers
that need to go in the middle of the burner
where there is more porng. Ensure no
klinkers are placed on top of the porng.
8. Place log # N41-4 so the right side of the log
aligns on the pin on top of #N41-3. Place the
le side of the log on the plaorm in the
center of the replace as shown. Slide this
log back towards the rear of the replace on
this plaorm.
9. Place log #N41-5 so it aligns with the pins
on #N41-1 and #N41-4 as shown.
Rev. 1
NOTE: Log numbers are located on the boom or side of each log. Refer to the following instrucons and illustraon for proper
placement. Your components may look dierent than the ones shown.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may aect ame appearance and may cause
excessive soot to build upon the glass.

#NK41-500 LOG SET
For use with model #NDK-41-DV
10. Reinstall the le and right burner assemblies. Reinstall the log rack / emberbed panel with the (4) previously removed
screws.
11. Install the crushed media on the emberbed and lava rock along the sides of the emberbed.
12. Place log #N41-7 on the le burner assembly by aligning the pins on the burner and the holes in the boom of the log. Re-
peat with log #N41-8 for the right burner assembly.
13. Place log #N41-9 around the center log rack as shown.
14. Place the larger klinkers / non-numbered log pieces on crushed glass media on front media tray.
15. Use a s or steel bristle brush to distribute rockwool embers onto the burners and logs.
Rev. 1