KRAFTWERK 38125 User manual

Art. 38125
www.KRAFTWERKtools.com
EN
Instruction manual
Portable hydraulic body repair kit
10 T

PRODUCT OVERVIEW
PRODUCT OVERVIEW
No. Description No. Description
01 Case
02 Extension bar 685 mm
03 Extension bar 456 mm
04 Extension bar 250 mm
05 Extension bar 127 mm
06 Serrated cap
07 Spreading wedge
08 Big rubber head
09 Base plate
10 Ram toe
11 Plunger toe
12 Cleft cap
13 „V“ base
14 Male connector
15 10 T Pump unit
16 Ram unit
17 Hydraulic hose
1
2
3
4 5 6 7 8
15 16
17
910 11 12 13 14
2
1. Never exceed the maximum load.
2. Never further extend the length of the lifting cylinder.
3. Always use protective caps to seal offconnectorsattached to accessories not being used.
4. Take care to ensure that the lifting cylinder always moves vertically in relation to the load.Should significant force be
exerted when pumping, re-adjust the cylinder so that it presses down vertically on the load.
5. Do not kink the hydraulic hose or place heavy objects on it.
6. Do not use the device in the vicinity of an open fire or in a strongly heated environment.

OPERATING INSTRUCTIONS
SUGGESTED SYSTEM ASSEMBLIES
RAM
RAM
PUMP
RUBBER RAM
HEAD
RUBBER RAM
HEAD
RUBBER
HEAD
SADDLE RAM
SPREADER
FLAT
BASE
FLAT
BASE
PLUNGER
TOE
EXTENSION EXTENSION
BASE
PLATE
For condined areas the hydraulic spreading wedge shoud be used
3
1. Use the pump together with the lifting cylinder and ensure that
all connectors are fastened correctly.
2. Close the valve by turning it clockwise.
3. Build up pressure in the pump by using the lever to make
pumping movements.
4. To release the pressure on the lifting cylinder, open the valve by
turning it anti-clockwise.
The pump can be used horizontally as well as vertically. When used
vertically, the hydraulic hose must be pointing downwards

4
MAINTENANCE
1. When the body repair kit is not in use, the pump unit should be
stored with the release valve open.
2. To check oil level, place the pump unit in an upright position. As
indicated on the diagram opposite. Remove the dip stick and the
oil level will be indicated. If required add hydraulic oil until it is
level with the full mark on the stem.
3. After extensive use, the oil supply should be replaced to ensure
longer equipment life. To drain, remove the dip stick and open
release valve. Ensure that no dirt gets into the system. Refill with
approved jack oil.
IMPORTANT:
USE ONLY CERTIFIED HYDRAULIC OIL WHEN TOPPING UP AND
REPLACING THE OIL.
www.KRAFTWERKtools.com
EN 1494: 2000+A1/2008
DECLARATIONOF CONFORMITY
Model: 38125
Portable hydraulic body repair kit 10 t
KRAFTWERK Sàrl, 25 rue due Stade, F-67870 Bischoffsheim
Declares under sole responsibility that the product to which this declaration relates is in conformity with the following
standard(s) or other normative document(s):
Following the provisions of Directive(s)
Machinery Directive:
Bischoffsheim, 28/02/2013
2006/42/EC
Patrick Wyss
President