Kramer VM-2DH User manual

VM-2DH Quick Start
P/N:
2900- 301266QS
Rev:
2
Scan for full manual
VM-2DH Quick Start Guide
This guide helps you install and use your VM-2DH for the first time.
Go to www.kramerav.com/downloads/VM-2DH to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VM-2DH DisplayPort to DVI/HDMI Converter
4 Rubber feet
1 Bracket set
1 Power supply (5V DC)
1 Quick start guide
Step 2: Get to know your VM-2DH
#
Feature
Function
1
EDID SETUP Button
Press to cycle through the EDID sources and to read the EDID (see Step 6)
2
IN LED
Lights green when the input is active; flashes when the input is not valid
3
OUT DVI LED
Lights green when a DVI acceptor output is connected
4
OUT HDMI™LED
Lights green when an HDMI acceptor is connected
5
ON LED
Lights green when the unit is powered on
6
DP IN DisplayPort Connector
Connect to the DisplayPort digital source
7
DVI OUT Connector
Connect to the DVI acceptor
8
HDMI OUT Connector
Connect to the HDMI acceptor
9
5V DC
Connect to the 5V DC power adapter, center pin positive
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Mount VM-2DH
Install VM-2DH using one of the following methods:
•Attach the rubber feet and place the unit on a flat surface.
•Fasten a bracket (included) on each side of the unit and attach it to a flat surface
(see www.kramerav.com/downloads/VM-2DH).
•Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/VM-2DH).
•Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•Avoid uneven mechanical loading.
•Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•Reliable earthing of rack-mounted equipment should be maintained.

Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your VM-2DH.
To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-2DH.
Using third-party cables may cause damage!
Step 5: Connect power
Connect the power cord to VM-2DH and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
•For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the
terminal or in the User Manual.
•There are no operator serviceable parts inside the unit.
Warning:
•Use only the power cord that is supplied with the unit.
•Disconnect the power and unplug the unit from the wall before installing.
Step 6: Operate VM-2DH
Initially the VM-2DH operates with the factory default EDID stored in the non-volatile memory. The source reads the EDID
from the device when the device is plugged in or powered on.
If required, acquire the EDID:
•Connect the output(s) from which you want to acquire the EDID.
•Select the required EDID by pressing and holding the EDID SETUP button to cycle through the options; HDMI OUT,
DVI OUT, Auto-Mix, and default.
•When you reach the desired setup, release the EDID SETUP button to acquire the EDID.