KRAMER
VS-211UHD Quick Start Guide
This guide helps you install and use your for the first time.
Go to to download the latest user manual (or scan the QR code)
and check if firmware upgrades are available.
VS-211UHD
http://www.kramerav.com/downloads/VS-211UHD
Step 1: Check what’s in the box
4 Rubber feet
1 Quick start guide
VS-211UHD Ultra HD HDMI Auto Switcher
1 Power cord supply (5V DC)
Step 2: Install the VS-211UHD
Step 3: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your .
always use Kramer high-performance cables to connect AV equipment to the VS-211UHD.
VS-211UHD For best results, we recommend that you
VS-211UHD Quick Start (P/N: 2900-300555QS REV 1)
Step 4: Connect the power
Step 5: Set the DIP-switches
Kramer RC-IR3 Infrared Remote Control
Transmitter with batteries and user manual
Attach the rubber feet and place on a table or mount the in a rack (using an optional RK-T2B rack mount).VS-211UHD
Connect the V DC power adapter to the and plug the adapter into the mains electricity.5 VS-211UHD
From DIP-30 PC Graphics +
Audio Source Smart TV Active
Speakers
Remote
Switches
PC Control
Device
P/N: Rev:
WWW.KRAMERAV.COM
1 Audio EDID Pass audio EDID of sink Limit to 2-CH LPCM
2 Color EDID Pass deep color parameter
of sink
Limit to RGB 8bpp
3 Lock EDID Pass EDID of sink Lock current display EDID
4 HDCP Support HDCP No HDCP support
5 Auto Embedding
Port 1
Always embed
Analog Audio In
Embed Analog Audio In, if DVI.
Audio only embedded when input is
DVI and 3.5mm connector is
connected
6 Auto Embedding
Port 2
Always embed
Analog Audio In
Embed Analog Audio In, if DVI.
Audio only embedded when input is
DVI and 3.5mm connector is
connected
7 Audio From Source ARC
8 Output Off Delay
Settings
15sec default (configurable) 15min
