Kyocera FS-C5016N Use and care manual

FS-C5016N Toner Replacement
To replace the toner container, first check the colour of the toner requiring
replacement.
Example shown is for the black toner.
1. Open up the top cover
fully.
2. Pull the blue lock lever
on the toner container
towards the unlocked
symbol.
3. Carefully remove the
old toner container
from the printer.
4. Put the old toner
container in the plastic
bag (contained in the
toner kit) and discard
it according to the
local regulations for
waste disposal.
5. Take the new toner container out of the toner kit.

6. Shake the new toner
container 5 or 6 times
as shown in the figure
in order to distribute
the toner evenly inside
the container.
7. Insert the new toner
container into the
printer as shown in
the diagram.
8. Push down on the top
of the toner container
to install it firmly in
place.
9. Pull the blue lock lever
on the toner container
back towards the
locked symbol as far
as it will go.

10. Close the top cover.
It is advised that the waste toner box is also replaced when a toner kit is fitted.
Replacing the Waste Toner Box
Replace the waste toner box each time you replace the toner container or
when the printer indicates to do so. A new waste toner box is included with
the toner kit.
1. Open the left cover.
Remove the waste toner box as gently as possible so as not to scatter
the toner inside. Do not let the opening of the waste toner box face
downward.
2. While holding the
waste toner box,
press the lock lever
and then gently
remove the waste
toner box.

3. Close the cap to the
old waste toner box
after removing the box
from the printer.
4. To prevent toner from
spilling, put the old
waste toner box in the
plastic bag (contained
in the toner kit) and
discard it later
according to the local
code or regulations for
waste disposal.
5. Open the cap of the
new waste toner box
6. Insert the new waste
toner box as shown in
the figure below.
When the box is set
correctly, it will snap
into place.
7. Make sure that the
waste toner box is
correctly inserted and
close the left cover.
Note: After replacing the toner containers and the waste toner box, clean the
main charger units and the paper transfer unit.