Kywoo3D Tycoon Max User manual

Ground Wire Instruction
1. Remove the yellow Chassis
Note: Turn Off the Power Supply, remove the handle, four
screws on the side and two screws on the bottom, when the
chassis is halfway down, use cutting pliers to remove the hot
melt glue on the ribbon cable. Unplug the ribbon cable before
removing the yellow case.
1
2
3
4
5

2. Connect the plug ground wire interface to the
power supply
2.1 Prepare a 35-40cm long wire, cut both sides flat and
expose the copper wire, as shown in the figure below:
2.3 Connect one end of the wire to the ground wire of the
switch and wrap it with insulating tape, as shown in the figure:

2.3. Connect the other end of the line to the third position of
the power interface (uncover the transparent baffle first ,
loosen the screw, insert the cable into the third port of the
power supply, lock the screw, and install the transparent
baffle).

3. After connecting both ends of the cable, plug in the
flat cable, install the yellow Chassis, install the screws
and handle and then plug in the power supply to test.