9/ 84
Adjusting the light mode
• Press the button for adjusting the
light once 1 to activate the
light with a greater intensity.
• Press the button for reducing
the intensity a second time.
• Press the button for starting the “breath-
ing” mode a third time; the light inten-
sity increases for 5 seconds, then de-
creases for 5 seconds, in cycles.
• Press the button a fourth time
to switch o the light.
The light switches o by default when dif-
fusion stops (either with the timer, or with
the system that automatically switches o
when the reservoir is empty). But it is pos-
sible to programme the light separately
from diusion.
• To do that, press the two buttons at the
same time 1 , . The left-hand and
middle indicators light up You will
then be able to enjoy the atmospher-
ic lighting, even after diusion stops.
• To de-activate independent program-
ming of the light, press both buttons
again at the same time. The middle and
right-hand indicators will light up .
Even though there is a safety device that
stops the transducer from working, do not
leave the device connected when you are
not using it.
Additional information about
the use of essential oils:
Before using essential oils, please check the
harmful eects that use of these products may
have on your health.
Always choose quality essential oils that are
pure, 100% natural and intended for diusion.
Use them in moderation and with care. Follow
the instructions and warnings stated on the
packaging of the essential oils, making sure in
particular that:
• Pregnant women, people with epilepsy,
asthmatics and people who suer from al-
lergies, those with heart problems or seri-
ous illnesses should not use essential oils.
• Essential oils should be used only
for periods not exceeding 10 min-
utes in the room of a baby (un-
der 3 years old) and only when the
baby is not actually in the room.
Make sure that children and minors do not play
with or use the device.
Just a few drops (3 to 4 drops at most) of essen-
tial oils are sucient to ensure that the device
