Larson Electronics EPL-FL1524-LED-100 User manual

EPL-FL1524-LED-100
Explosion Proof LED Drop Light Instruction
Manual

I. Installation & Maintenance
1
I. Re-lamping
1. Remove the 4 screws located at the bottom
of the lamp.
2. Pull cap gently and evenly away from the
xture.
3. Remove LED tube and replace (must use
our LEDT8-F15 bulb).
4. Slide assembly back into handle and fasten
securely with the 4 screws.
II. Maintenance
Make sure that power is OFF before servicing
or replacing any parts. Maintenance should be
performed in non-hazardous areas.
To maintain peak efciency, clean the exterior
daily.
Check cable for severe abrasion, cuts or
breaks and replace if necessary.
Remove to re-lamp

2
IV. Safety Warnings and Ratings
I. Warnings
WARNING: Risk of electric shock - never
connect to, disconnect from or service while
equipment is energized.
WARNING: Risk of re - Lamps are hot.
Keep combustible material away from the
hot parts. Observe lamp manufacturer’s
warnings, recommendations and restrictions
on lamp operation and maintenance. Make
sure lamps are correctly installed.
DO NOT use this electrical equipment for
anything other than its intended use.
The use of accessory equipment is not
recommended by the manufacturer and will
void product listing and warranty, and may
cause unsafe conditions.
Any service on this equipment should be
performed by qualied personnel only.
Make sure to always check the voltage on
the xtures nameplate before use.
While this xture is explosion proof,
the cord cap is NOT. The plug should
always be used outside of any hazardous
location.
II. Ratings/Approvals
Class I, Divisions 1 & 2 Group D
Class II, Division 1 Groups E, F, G
Class III, Divisions 1 & 2
III. Features
Non-sparking Aluminum Housing
No Ballast
Molded Rubber Bumper Guards
Annealed Glass Tube Shields
Integrated Lamp Shock Absorbers
Swivel Hook
Explosion Proof Cord
IV. Options
Voltage:
120-277V AC
11-25V AC/DC
Cord Cap:
5-15 Straight
6-15 Straight
L5-15 Twist
L6-15 Twist
UK BS1363
Intl Schuko
Pigtail