Larson Electronics LE-224-LED User manual

LE-224-LED
Explosion Proof LED Spotlight Instruction
Manual

1
Congratulations on the purchase of your new Handheld LED
Spotlight. Please read these instructions carefully to familiarize
yourself with the safe operation and maintenance of your new
flashlight. Following these instructions will insure many years of safe
and dependable service.
Table of Contents
I. Operating Instructions 2
I.I Assembly 2
I.II Operation 2
II. Warnings 3
VI. Warranty and Disclaimer 4
VI.I Limitation of Liability 4
VI.II Conditions 4
VII. Return Requests and Inquiries 5
8.1 Warranty Returns 5
8.2 Non-Warranty Returns 5

2
Return to Table of Contents
I. Operation and Battery/Bulb Replacement
I. Operation
This flashlight features a simple slide
switch for easy operation. Operators
slide the switch up to turn on,
down to turn off or in the middle for
momentary.
II. Battery Replacement
Unscrew the bottom cap and install approved
batterieslike shown below. Once batterieshave
been place, screw the bottom cap back on.
Slide to top for on
Slide to middle for momentary
Slide to bottom for off
Insert batteries (+ side first)
and replace cap.

3
Return to Table of Contents
II. Safety Warnings and Ratings
For personal safety, always follow the safety instructions in this manual to ensure safe and long-
term use. Failing to do so can result in damage to the product or serious bodily injury.
I. Warnings
Never place flashlight face down when light is
on or is still hot from recent use. Doing so could
burn/ignite surfaces such as seats, carpeting,
etc. and cause major property damage.Always
turn spotlight off when not
in use.
To prevent serious damage to eyesight, never
look into spotlight when light is on. DO NOT
shine light into the face of someone else.
DO NOT touch lens of spotlight when light is on
or if it was recently on. The lens will be hot and
could cause serious burns.
DO NOT allow children to handle or operate
this spotlight.
DO NOT use this product for other than its
intended use.
DO NOT operate in close proximity of
combustible or flammable materials.
DONOTattempttooperatethisspotlightifcord,
plug, battery, bulb or any part of the spotlight is
damaged or corroded.
DO NOT remove lens ring.
DO NOT allow metal parts to touch metal
contacts on battery as this can cause a short
circuit and result in a fire.
DO NOT disassemble or tamper with the
battery.
DO NOT dispose of battery in fire as this may
result in explosion.
II. Ratings
Class I, Division 1, Group C & D
Class I, Division 2, Group A, B, C, & D
Class II, Division 2, Group G
ASTM & MSHA:Approved

4
Return to Table of Contents
VI. Warranty and Disclaimer
Larson Electronics’, LLC. LarsonElectronics.com warrants this unit to be free of defects in materials
and workmanship for a period of three (3) years from the date of
purchase.
If the unit should malfunction, it must be returned to the factory for evaluation. Larson Electronics’
Customer Service Department will issue a Returned Merchandise Authorization (RMA) number
immediately upon phone or written request. Upon examination by Larson Electronics’, if the unit is
found to be defective it will be repaired or replaced at no charge. Larson Electronics’WARRANTY does
not apply to defects resulting from any action of the purchaser, including but not limited to mishandling,
improper interfacing, operation outside of design limits, improper repair, or unauthorized modification.
This WARRANTY is VOID if the unit shows evidence of having been tampered with or shows evidence
of being damaged as a result of excessive corrosion; or current, heat, moisture or vibration; improper
specification;misapplication;misuseorotheroperatingconditionsoutsideofLarsonElectronics’control.
Larson Electronics’ is pleased to offer suggestions on the use of its various products. However, Larson
Electronics’ neither assumes responsibility for any omissions or errors nor assumes liability for any
damages that result from the use of its products in accordance with information provided by Larson
Electronics’, either verbal or written. Larson Electronics’ warrants only that the parts manufactured by
it will be as specified and free of defects.
LIMITATION OF LIABILITY
The remedies of purchaser set forth herein are exclusive and the total liability of Larson Electronics’
with respect to this order, whether based on contract, warranty, negligence, indemnification, strict
liability or otherwise, shall not exceed the purchase price of the component upon which liability
is based. In no event shall Larson Electronics’ be liable for consequential, incidental or special
CONDITIONS
Should any Product(s) be misused in any way, Larson Electronics’ assumes no responsibility as set
forth in our basic WARRANTY / DISCLAIMER language, and additionally purchaser will indemnify
Larson Electronics’ and hold Larson Electronics’ harmless from any liability or damage whatsoever
arising out of the use of the Product(s) in such a manner.

5
Return to Table of Contents
VII. Return Requests and Inquiries
Directallwarrantyandrepairrequests/inquiriestotheLarsonElectronics’CustomerServiceDepartment.
BEFORE RETURNING ANY PRODUCT(S) TO LARSON ELECTRONICS’, PURCHASER MUST
OBTAIN A RETURNED MERCHANDISE AUTHORIZATION (RMA) NUMBER FROM LARSON
ELECTRONICS’ CUSTOMER SERVICE DEPARTMENT (IN ORDER TO AVOID PROCESSING
DELAYS). The assigned RMA number should then be marked on the outside of the return package
and on any correspondence.
The purchaser is responsible for shipping charges, freight, insurance and proper packaging to prevent
breakage in transit.
For WARRANTY RETURNS please
have the following information available
BEFORE contacting Larson Electronics
1. Order number under which the product
was PURCHASED.
2. Model and serial number of the product
under warranty.
3. Repair instruction and/or specific
problems relative to the product.
For NON-WARRANTY REPAIRS consult
Larson Electronics LLC for current repair
charges. Have the following information
available BEFORE contacting Larson
Electronics LLC:
1. Order number to cover the COST of the
repair.
2. Model and serial number of product.
3. Repair instructions and/or specific
problems relative to the product.
LarsonElectronics’policyisto make runningchanges,notmodelchanges,wheneveran improvement
is possible. This affords our customers the latest in technology and engineering.
Larson Electronics’ is a registered trademark of LARSON ELECTRONICS’, LLC.
© Copyright 2017 LARSON ELECTRONICS LLC. All rights reserved. This document may not be
copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-
readable form, in whole or in part, without prior written consent of LARSON ELECTRONICS’ LLC.