Laser Dollhouse Designs Victorian Farmhouse User manual

Victorian Farmhouse assembly instructions
By
Laser Dollhouse Designs

First Floor
Lay first floor upside down and assemble base supports by inserting into first floor slots. Once installed turn right side up. You
should see the numbers 1A thru 1P for inserting the walls.

First Floor

1G
1B
1H1J
1F
1A
1C
1D
1E
1K
1M
1O
1P
Insert walls 1A thru 1P, match the wall tabs to first floor slots.

Insert the small porch side frame.

All Plexiglass goes inside
opening in walls and the
frames glue to the walls to
hold in place

Insert porch frames

2nd Floor
Assemble stairs and install prior to placing the 2nd floor on as this will prevent you from inserting stairs later.

2nd Floor

2nd Floor
Insert safety rails on 2nd floor.

2E
2F
2I2J
2C
2A
2B
2G
2H
2K
2M
2O
2P
2D
Locate walls 2A thru 2P. Note there is no 2L or 2N.

Insert 2nd floor porch rails.

All Plexi glass goes inside
opening in walls and the
frames glue to the walls to
hold in place

3rd Floor
Assemble stairs and follow same process as earlier for 2nd floor.

3rd Floor

Ok 2ND Floor complete. On to the 3rd.

3C
3D
Install wall 3A and 3D along with the 3 dividers in the middle.

Install 3rd floor roof. Note that the top back goes facing up and to the rear for proper alignment.