Laser Dollhouse Designs Victorian Gazebo II User manual

The Victorian Gazebo II Assembly Instruction
By Laser Dollhouse Designs

Parts for Assembly
Frame Rails roof frames Base support frames
roof base
support frames
Turret rings numbered
0-20 (Note in 1:48 only
Numbered from 1-10 Stairs Assembly
Chair Assembly 8 Roof rail frames
Lower and mid
Roof support s
Upper and
lower base

Step 1. locate the upper Base as seen in
Figure 1 and flip upside down. Position
the single notch facing toward you.
Figure 1
Step 2. Take the base support with the
engraved company name and insert to the
rear. Make sure single tab is facing up, see
figure 2.
Figure 2

Step 3. Locate the base support with only one
center tab and insert to the front as seen in
figure 3
Step 4. Place the remaining base supports into the outer
slots making sure that the center tab only side faces up.
See figure 4.
Figure 3
Figure 4
Step 5. Place the bottom base by aligning slot openings to
base support tabs. See figure 5.
Figure 5

Figure 7
Step 7. Insert gazebo frame rails as seen in figure 7
Step 6. Flip completed base right side up. See figure 6
Figure 6

Step 8. Install lower roof support ring as seen in
figure 8.
Figure 9
Figure 8
Step 9. Install roof rails and mid roof
support as seen in figure 9.

Step 10. Add gazebo turret ring T0 as seen in
figure 10. ( Note this is T1 in 1:48 scale)
Figure10
Step 11. Install center guide into turret ring
as seen in figure 11.
Figure11

Step12. Install the remaining rings by following the
numbers or make your own design. See figures 12
Figure13
Figure12
Step13. Cut excess of remaining unused
center guide with a knife. Once cut sand
point to desired length. See figures 13

Step 14. Install roof alignment guide frames
as seen in figure 14
Figure14
Step 15. Continue with supports until all eight are in place
as seen in figure 15
Figure15

Step 16. Install roof base support frames, wider end
faces up, as seen in figure 16
Figure16
Figure17
Step 17. Continue with supports until all eight are in place
as seen in figure 17

Figure18
Step 18. Install stairs as seen in figure 18
Figure19
Step 19. Assemble chair lower section as
seen in figure 19

Figure20
Step 20. Add seat back as seen in
figure 20 . Put stair inside or outside
gazebo as you see fit. Gazebo is
completed.

Laser Dollhouse Designs
www.laserdollhouses.com
Email: [e-mail]