LeapFrog Build-a-Slice Pizza Cart User manual

Instruction Manual
This manual contains important information. Please save it for future reference.
Build-a-Slice Pizza Cart
Build-a-Slice Pizza Cart
Build-a-Slice Pizza Cart
Build-a-Slice Pizza Cart

2
INTRODUCTION
Thank you for purchasing the Build-a-Slice Pizza Cart™!
Explore counting, colours and even some Italian phrases while
making, baking and delivering your own pretend pizzas!
Ding! Ding! Order up!
Off/Low/High
Volume Switch
Pizza Slice
Pieces
Oven
Door
Temperature
Dial
Till Button
Pizza
Spinner
Storage
Drawer
Pizza Toppings
Tray
Menu Board
Handle
Canopy &
Sign
Shelf
Order
Bell
Pizza
Topping
Pieces
Notes
Coins
Magic
Spatula
Pizza Cutter
Cheese
Shaker
Pizza
Paddle
Pizza
Box
Plate

3
INCLUDED IN THE PACKAGE
1 canopy & sign
1 Build-a-Slice Pizza Cart™
1 handle 1 price menu board

4
6 pizza toppings
1 pizza cutter
10 notes
1 cheese shaker
5 coins 1 plate
4 pizza slices1 chimney
1 pizza paddle

5
WARNING
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging
screws are not part of this toy and should be discarded for
your child’s safety.
NOTE
Please save this Instruction Manual as it contains important
information.
NOTE :
After removing from packaging, wipe all the included pieces
using a slightly damp cloth. Wash the Pizza Cutter, Plate and
the Oven Paddle thoroughly before and after use. To avoid
damaging the electronics, do not submerge the items in
water or expose them to excessive moisture.
1 pizza box 1 customer label
• Quick Start Guide

6
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a
screwdriver to loosen the screw and then open the battery
cover.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install 3 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.

7
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in
fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy
before charging.
• Rechargeable batteries are only to be charged under
adult supervision.
• Do not charge non-rechargeable batteries.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

8
Disposal of batteries and product
The crossed-out wheelie bin symbols on products
and batteries, or on their respective packaging,
indicates they must not be disposed of in domestic
waste as they contain substances that can be
damaging to the environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the
specified value of mercury (Hg), cadmium (Cd) or
lead (Pb) set out in the Batteries and Accumulators
Regulation.
The solid bar indicates that the product was placed
on the market after 13th August, 2005.
Please dispose of your product and batteries responsibly.
In the UK, give this toy a second life by disposing of it at a
small electricals collection point* so all of its materials can be
recycled.
Learn more at:
www.leapfrog.co.uk/recycle
www.leapfrog.com.au/recycle
* Visit www.recyclenow.com to see a list of collection points
near you.

ASSEMBLY
With the Build-a-Slice Pizza CartTM safety comes first. To ensure
your child’s safety, adult assembly is required.
1. Insert the Chimney and Price Menu Board firmly into the top
of the Pizza Cart.
2. Attach the Canopy & Sign onto the Chimney and Price Menu
Board.
9

3. Insert the Handle into the top of the Pizza Cart.
LABEL APPLICATION
Please securely stick the labels to the cart as indicated below.
Match the label numbers to the corresponding numbered spots
on the cart. Note: Two spots on the Canopy will not receive
labels. They are intended to remain green.
1 2 3 4
1
2
3
4
5
5
10