Legacy Classic Furniture 6400 User manual

ASSEMBLY INSTRUCTIONS:
Parts & Hardware List:
Thank y u f r purchasing this quality pr duct. Bef re beginning, please check the packing material carefully
f r small parts which may have c me l se inside the cart n during shipping. Please d n t discard any
packing material until all parts have been l cated. If any parts are missing, please c ntact y ur dealer f r
pr mpt replacement.
www.legacyclassic.c m
Caution: (1) These parts are cumbers me and heavy. This pr duct can best be assembled with the
assistance f ne r m re pers ns in rder t prevent pers nal injury and t insure parts are n t damaged
during the assembly pr cess. If dirty, clean finished parts with mild dishwashing liquid and water s luti n
applied n damp cl th. Cl th sh uld n t be excessively wet. P lish finish with s ft cl th and an industry
rec gnized furniture p lish.
(2) T prevent damage t y ur fl r r carpet, please check the b tt m f each piece f furniture
f r stain residue and r ugh surfaces and als check f r staples r nails left after rem ving the packaging
material. The manufacturer will n t be held resp nsible if preventative steps are n t taken pri r t
installati n.
(3) During n rmal use everyday, screws, b lts, nuts and w den plugs may l sen up. They
sh uld be peri dically inspected and re-tightened t prevent damage t the furniture and ( r) pers nal
pr perty r cause injury. Always check t be sure all hardware n this list and the bel w menti ned
c mp nents are attached t the furniture pr perly and kept tightened.
6400/6401-4105/4125/4904 PANEL BED QUEEN 5/0
PARTS LIST Q'TY
1 PC
B
HEADBOARD
FOOTBOARD
A
PARTS LIST Q'TY
2 PCS
BED RAIL
E
HARDWARE LIST Q'TY
8 PCS
2
BOLT
LOCK WASHER
1
Q'TY
12 PCS
6
8 PCS
7
SHORT SCREW 20 PCS
5
HARDWARE LIST
5/16"
1 PC 8 PCS
LONG SCREW
6 PCS
LONG
SUPPORT LEG
F
LEGACY CLASSIC
FURNITURE
Step 2 Step 3
FOOTBOARD
LEG
SHORT
SUPPORT LEG
SLAT
MATTRESS
PANEL
C
D
G
H
2 PCS
3 PCS
4 PCS
5 PCS
3
87*12mm
4WRENCH 1 PC
8*1-1/4"
8*1"
D
C
B
4
3
2
7
1
8 PCS
5/16"*3"
5/16"
NUT CURVED
WASHER 5/16"

ASSEMBLY INSTRUCTIONS:
www.legacyclassic.com
6400 6401-4105 4125 4904 PANEL BED QUEEN 5 0
Assembly Procedures:
Step 1: Lay out all parts and hardware. Make sure the quantity of each is correct and the feet are free of
stain, staples, screws and nails.
Step 2: Remove the drawers from storage footboard (B) as shown. Assemble the short support leg (D) and
the footboard leg (C) to the footboard (B) as shown.
Step 3: Assemble the bed rails (E) to the headboard (A) and footboard (B) using hardware (1, 7, 2, 3, 4) as
shown.
Step 4: Assemble the long support legs (G) to the slats (F), then put the slats (F) on the bed rails and fasten
the long wood screws (5) as shown. The support leg leveler needs to touch the floor to support the
slats and mattress.
Step 5: Place the mattress support panel (H) on bed slats one by one and attach with short wood screw (7) as
shown. Insert the drawers in storage footboard as shown.
Assembly is complete.
Step 4
LEGACY CLASSIC
FURNITURE
Step 5
F
G
6
F
G
5