Legacy Classic Furniture Trestle 0420-621 User manual

www.legacyclassic .com
ASSEMBLY INSTRUCTIONS LEGACY CLASSIC
FURNITURE
0420-621 TRESTLE DINING TABLE
Thank you for purchasing this quality product. Before beginning, please check the packing material carefully for
small parts which may have come loose inside the carton during shipping. Please do not discard any packing
material until all parts have been located. If any parts are missing, please contact your dealer for prompt
replacement.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the assistance of
one or more persons in order to prevent personal injury and to ensure parts are not damaged during the assembly
process. If dirty, clean finished parts with mild dishwashing liquid and water solution applied on damp cloth.
Cloth should not be excessively wet. Polish finish with soft cloth and an industry recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) During normal use every day, screws, bolts, nuts and wooden plugs may loosen up. They should
be periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the below mentioned components are attached to the
furniture properly and kept tightened.
Parts & Hardware List:
C
C
D
Step 2
2
3
PARTS LIST QTY
A TABLE TOP 1 PC
B LEAF 1 PC
C LEG 2 PCS
D STRETCHER 1 PC
HARDWARE LIST QTY
1 BOLT + LOCK WASHER + FLAT WASHER ----- 1/4” Dia 2-1/2” L 8 SETS
2 BOLT + LOCK WASHER + FLAT WASHER ----- 5/16” Dia 2-1/2” L 4 SETS
3 WRENCH 10-12*85mmL 1 PC

www.legacyclassic .com
ASSEMBLY INSTRUCTIONS LEGACY CLASSIC
FURNITURE
0420-621 TRESTLE DINING TABLE
C
C
D
A
A
Step 3
3
1
A
A
B
Step 4
Assembly Procedures:
Step 1: Lay out all parts and hardware. Make sure the quantity of each is correct and the feet are free of
stain, staples, screws and nails.
Step 2: Assemble the stretcher (D) to the leg (C) using hardware as shown (2,3).
Step 3: Assemble the leg (C) to the table top (A) using hardware as shown (1,3).
Step 4: Turn the table to its upright position. Unlock the lock mechanism under the table top before pulling it
apart and then carefully remove or insert the table leaf (B) as shown.
NOTE: If handled improperly, the act of installing and removing table leaf may damage the table. Please use
caution and delicate handling when installing and removing table leaf to prevent damaging the table top surface and
edges. It is best to persons are involved when installing or removing table leaf.
Assembly is complete.