Legacy Classic Furniture CREDENZA 931-151LC User manual

Assembly Instruction
931-151LC CREDENZA W/MARBLE
Thank you for purchasing this quality product. Be sure to check all packing material carefully for
small hardwares, which may have come loose inside the carton during shipment. Identify and count all
hardwares and compare with the Hardware List below.
Caution: (1) Parts are cumbersome and heavy. This product can best be assembled with the
assistance of two or more persons in order to prevent personal injury and to insure parts are not
damaged during the assembly process.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of
furniture for stain residue and rough surfaces and also check for staples or nails left after removing the
packaging material. The manufacturer will not be held responsible if preventative steps are not taken
prior to installation.
(3) Use only the screws included in the package. Using different sizes could cause the wood
to split or come out from the other side.Phillips head screwdriver required for assembly.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They
should be periodically inspected and re-tightened to prevent damage to the furniture and (or) personal
property or cause injury. Always check to be sure all hardware on this list and the above mentioned
components is attached to the furniture properly and kept tightened at all times.
www.legacyclassic.com
Assembly Procedures:
Assemble front and back bun feet by Bolt(5), Flat Washer (6) and Lock Washer(7) as shown in the Figure A. Note:
1.X-Shaped Wine Rack and Shelf are interchangeable.
2.Install Tipping Restraint. Installation Instructions are located inside the tipping restraint kit. Important: the use of
the furniture tipping restraint is highly recommended. This hardware, when properly installed, could provide
protection against the unexpected tipping of furniture due to improper use.
Assembly is now complete.
(Figure A)
(Figure B)
Adjustable leveler
5
6
7
5
6
7
Adjustable leveler
Front Bun Feet
Back Bun Feet
X-Shaped Wine Rack
Shelf
Bolt: 1/4"Dia * 2-1/2"L
Flat Washer 1/4"Dia
Lock Washer 1/4"Dia
ST3.5 * 3/5" Screw
Shelf Support
Tipping restraint kit

www.legacyclassic.com