Legrand Kenall luxtran tlr4 series User manual

www.kenall.com |P: 800-4-Kenall |F: 262-891-9701 |10200 55th Street Kenosha, Wisconsin 53144, USA

This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents

INSTALLATION INSTRUCTIONS

TLR4_F-5474_091118

Luminaires for Tunnel Applications

LUXTRAN™

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed, including the following:

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION

CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND

THE HAZARDS INVOLVED. CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION

PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT

AINSI QUE LES RISQUES INHÉRENTS. DISCONNECT POWER TO ALL CIRCUITS BEFORE WIRING FIXTURE. INSTALL IN

ACCORDANCEWITHALLNATIONAL,STATE,ANDLOCALCODES.DONOTCONNECTTOANUNGROUNDEDSUPPLY.READALL

FIXTUREMARKINGSANDLABELSTOENSURECORRECTINSTALLATIONOFFIXTURE.SUPPLEMENTALINSTRUCTIONSMAYBE

LOCATEDONTHEFIXTURE,INADDITIONTOTHISINSTRUCTIONSHEET,REGARDINGORIENTATION,ORMOUNTINGRESTRICTIONS.

SAVE THESE INSTRUCTIONS

INSTALLATION INSTRUCTIONS

TLR4 SERIES

1. After removing existing wireway gasket and cleaning surface, install provided gasket and seal joints with RTV.

2. Wire provided socket assemblies to existing 277VAC input wiring.

Black- 277VAC input

White- Neutral

Green- Ground

3. Place latch brackets over wireway. See Figure 1. Connect green ground wire from cover to ground connection in

wireway. Feed connector with Red and Blue wires from master xture through wireway and connect to satellite

xture. Master xtures on segments with one xture will have long leads.

Figure 1

GROUND WIRE

277VAC INPUT

MASTER FIXTURE

SATELLITE FIXTURE

MASTER FIXTURE

SATELLITE FIXTURE

Figure 2

www.kenall.com |P: 800-4-Kenall |F: 262-891-9701 |10200 55th Street Kenosha, Wisconsin 53144, USA

This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents

INSTALLATION INSTRUCTIONS

TLR4_F-5474_091118

Figure 3

4. Connect socket to xture receptacle and push wiring back into wireway.

5. Raise xture and secure using rotary latches on latch brackets. See Figure 3.

Figure 4

LOOSEN WINGNUT TO RELEASE

CABLE TO REMOVE DOOR

STAINLESS STEEL CABLES SECURE

DOOR WHEN OPEN

6. Drivers and led modules attached to door assembly for easy replacement.

7. Door assembly secured by two (2) stainless steel cables when opened.

8. Driver and surge protector supplied with wago luminaire disconnects for quick replacement.

www.kenall.com |P: 800-4-Kenall |F: 262-891-9701 |10200 55th Street Kenosha, Wisconsin 53144, USA

This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents