Lexmark 20T3600 - T 620 B/W Laser Printer User manual

Lexmark™ T620 and T622
StapleSmart™ Finisher
Quick Reference
Attaching the stacking paper bail
1Lift the finisher output bin cover until it locks into position.
2Snap the two paper bail posts into the slots under the output
bin cover.
Adjusting the stacking paper bail
Slide the end of the paper bail in or out until the paper size for your
print job is aligned with the arrow.
Using the paper bail hook
The paper bail hook prevents individual sheets in the output bin
from sliding forward when a large stapled or offset job is pushed
into the output bin. To use the paper bail hook, adjust the paper
bail to the longest paper size in your printer and rotate the hook
from the storage position. When not using the paper bail hook,
snap it back into the storage position.
Clearing staple jams
281 (or 282) Staple Jam
Check Stapler
1Lift the finisher output bin cover until it locks into position.
2Remove the stack of paper.
3Continue with step 1 in the 283 Staple Jam section (for
282 Staple Jam only).
283 Staple Jam
Check Stapler
1Press the latch to open the stapler access door.
2Firmly pull the colored tab to remove the staple cartridge
holder from the stapler.
3Orient the cartridge holder as shown in the illustration in
step 4.
4Use the metal tab to lift the staple guard, and then pull out the
sheet of staples.
Discard the entire sheet.
5Remove any loose staples inside the staple guard.
6Look through the clear covering on the bottom of the
cartridge holder to make sure no staples are jammed in the
entry throat.
7Press down on the staple guard until it snaps securely into
place.
8Push the cartridge holder firmly into the stapler until the
cartridge holder clicks into place.
9Close the stapler access door.
Priming Stapler appears on the operator panel display.
Priming occurs automatically to ensure the stapler is
functioning properly.
10 Close the finisher output bin cover.
Troubleshooting
If stapled print jobs do not bind together in a neat set, you may
need to replace the paper alignment wheels.
To order replacement wheels with a maintenance kit, use par t
number 99A2480. Refer to the Publications CD for more
information on maintenance kits.
If you are in the U.S. or Canada, call 1-800-438-2468 for
information about Lexmark authorized supplies dealers in your
area, or visit the Lexmark Web site at www.lexmark.com. In other
countries, contact the place where you bought your printer.
Paper bail
hook
Staple cartridge holder
Stapler
Staple guard
E.C. 1K1255 P/N 11K3892
Copyright © 2001 Lexmark International, Inc. All rights reserved.
Printed in U.S.A.
Thisdocument isprinted on recycled paper. 2/01