LG LW1013ER User manual

OWNER’S MANUAL
AIR CONDITIONER
Please read this manual carefully before operating
your air conditioner and retain it for future reference.
P/NO MFL67654001
www.lgappliances.com
TYPE WINDOW
MODELS LW8013ER,LW1013ER

7
16
20
Safety Precautions
Maintenance and Service
Before Operation
Introduction
Electrical Safety
Installation
Operating Instructions

Do not store flammables like
gasoline benzene thinner
etc. near the air conditioner.

No correlation between fan
usage and oxygen depletion. Unplug the unit when not
using it for a long time.

Hold the plug by the head
it out.
（not the cable）when taking Never touch the metal parts
of the unit when removing
the filter.
Install the product so the exhaust and noise
are not aimed directly at the neighbors.
When gas leaks, open the
window for ventilation before
operating the unit.
Be considerate.
Follow installation instructions exactly.
For inner cleaning, contact an Authorized Service Center or a dealer.
Do not use harsh detergent that causes corrosion or damage on the unit.
Harsh detergent may also cause failure of product, fire, or electric shock.

y
If you eat the liquid from the battery,brush
your teeth and see doctor.Do not use the
remote if the battery have leaked.
y
Do not use this appliance for
special purposes such as
cooling pets foods，
precision
machinery，or objects of art
，
You will feel better.
Instead of running air conditioning
constantly，open a window
for fresh air occasionally.
You will feel better.
If the liquid from the battery gets onto your skin
or clothers，
wash it well with clean water. Do
not use the remote if the battery has leaked.

2. No correlation between fan usage and oxygen depletion.
3.

RESET
TEST
9
should be
Avoid shock hazard. This unit cannot
be user-serviced. Do NOT open the
tamper-resistant sealed portion.
All warranties and performance will
be voided. This unit is not intended
to be used as an ON/OFF switch.

Left Guide Panel Right Guide Panel
Curtain
Phillips head
screwdriver
Scissors or
knife
11

Height
Width
(refer to below table).
height
Model （inches）Height Min
LW8013ER 13
LW1013ER 16
Width （inches）
22-36
23-36
12
Clearance
(Type D)
drawing
in the drawing.

upper and bottom guide.
with4screws(TypeA)oneachside.
(Type D)
13
Upper Guide
Bottom Guide
Left Guide Panel Right Guide Panel

(Type D)
(Type A).
1-1. Set the air conditioner in the window
so that is centered. Place the air
conditioner so that front edge of the
bottom guide is against the back
edge of the sill.
(Type G)
4
(Type B) to secure them.
1-2. Bring the window down so that the
front edge of the upper guide is in
front of the window. Make sure that
air conditioner is level or tilting
slightly to the outside.
L Bracket(Type D)
Screw
(Type A)
Screws
(Type B)
Sash Seal
(Type F)
Bracket
Bottom Guide
CAUTION
To prevent broken glass or
damage to windows, on vinyl or
other similarly constructed
windows, attach the window
locking bracket to the window
side jamb with one Type A screw.

3-4
3-3. Remove the screw from the right
side of cabinet.
Screw
(Type B)

- when the air conditioner is off, it can be set to automatically turn
OPERATION MODE SELECTOR
the desired fan speed.
- when the air conditioner is on, it can be set to automatically turn
on from 1 to 24 hours at its previous mode and fan settings.
off from 1 to 24 hours.
Everytime you push this button，it will toggle between Cool，Energy Saver，Fan, and Dry.
Delay ON
Delay OFF
ON/OFF TIMER
Cool - Compressor runs and cools the room. Use the and FAN buttons
to set the desired temperature and circulation fan speed.
Energy Saver - The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air
temperature if cooling is needed.
Fan - Fan circulates air but compressor does not run. Use the FAN button to set
Operation starts when this button is pressed and stops when you
press the button again.
FAN SPEED SELECTOR
Use to set the fan speed to Low (F1), MED (F2), High (F3).
Power
Temp
Fan Speed
Timer Mode
REMOTE CONTROLLER
POWER

Once the set temperature is reached，the compressor and circulation fan turns off.
Dry - Dry mode is used to remove humidity from the room without additional cooling.
Fan speed is pre-set and cannot be adjusted.
TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60 F~86 F (16 C~30 C).
REMOTE CONTROL SENSOR
During operation in failure of electric power, the unit runs as previous setting operation.
Do not use rechargeable battery. Make sure that the battery is new.
Do not mix alkaline, standard (Carbon-zinc) or rechargeable (Nickel-cadmium)
battery.
- In order to prevent discharge, remove the battery from the remote control if
the air conditioner is not going to be used for an extended period of time.
To maintain optimal operation of the remote control, the remote sensor should
not be exposed to direct sunlight.
Keep the remote control away from extremely hot or humid places.
1. Push out the cover on the back of the remote control with your thumb.
2. Pay attention to polarity and insert one new AAA 1.5V battery.
3. Reattach the cover.
CAUTION
The remote controller will not function properly if strong light strikes the sensor of the air
conditioner or if there are obstacles between the remote controller and the air conditioner.

Adjusting horizontal air flow direction Adjusting vertical air flow direction
The horizontal direction is adjusted
by moving the lever to the left or right. Touch the horizontal louvers to adjust the air airflow up or down.
NOTICE
When the unit operates in extremely hot weather, it turns off automatically to protect compressor.

19
drain
base pan
base pan

Inlet Grille
1. Pull the inlet grille forward.
2. Remove the air filter from the front grille by pulling the air filter up slightly.
3. Wash the filter using lukewarm water below 40
4.Gently shake the excess water from the filter and replace.