Life Fitness TR9100 Use and care manual

Life Fitness Model TR9700, TR9500, TR9100 Treadmills
How To...Replace or Install Rear Roller Guards
Tools Required: Philips Screwdriver
NOTE: The following steps are applicable to units with Configuration No. 1, Rear Roller Guards.
1. Remove the Screws securing the Rear Roller Guard Assembly to the Frame.
2. Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame (model
specific).
3. Install the new Grommets (included in kit) in the Rear Roller Guard Weldment and Base Frame
locations.
4. Place new Roller Guard in position as shown with the top surface under walking belt. Align mounting
holes.
Roller Guard to be
located between belt
and deck
Align mounting holes
with grommet holes
Cover Guard
Roller Guard, RT
Roller Guard, LT
Screw
Grommet
Screw
Grommet
Configuration No. 1

Life Fitness Model TR9700, TR9500, TR9100 Treadmills
How To...Replace or Install Rear Roller Guards
5. Install Screws and fasten securely. Approx. 22-37 in/lbs.
6. Repeat steps for opposite side. After completion run treadmill and check for interference or binding. If
needed loosen Mounting Screws, re-align Guard, and refasten securely.
Secure Mounting
Screws

Life Fitness Model 97Ti, 95Ti, 93T Treadmills
How To...Replace or Install Rear Roller Guards
Tools Required: Philips Screwdriver, Flat Blade Screwdriver
NOTE: The following steps are applicable to units with Configuration No. 2, Rear Roller Guards.
1. Remove existing Roller Guard by unscrewing mounting screws on top and base of frame.
2. With flat blade screwdriver, remove Grommet and Washer, discard old washer and re-install the
grommet. Use caution to prevent injury or damage to paint.
NOTE: Do not replace washer. Having a washer and the grommet will raise the guard too high
and cause rubbing against the belt resulting in premature wear and reducing belt life.
3. Remove the Base’s Lower Head Grommet for the base bottom hole and move to the upper hole in
the Base Frame.
Mounting
Screws

Life Fitness Model 97Ti, 95Ti, 93T Treadmills
How To...Replace or Install Rear Roller Guards (Continued)
4. Place new Roller Guard in position shown with top surface under walking belt. Align mounting holes.
5. Install Screws and fasten securely. Approx. 22-37 in/lbs.
6. Repeat steps for opposite side. After completion run treadmill and check for interference or binding. If
needed loosen Mounting Screws, re-align Guard, and refasten securely.
Roller Guard to be
located between bel
t
and deck Align mounting holes
with grommet holes
Secure Mounting
Screws
M051-00K58-A128