Lightmybricks LEGO Ninjago City 70620 Lighting Kit User manual

The following page is instructions for the Light My Bricks LEGO Ninjago City (70620)
LED light kit. You purchase this kit on our ofcial website.
To ensure a trouble-free installation of your light kit, please read and follow each step
carefully.
If you run into any issues, please refer to the online troubleshooting guide.
This user guide is also available to download in PDF format here.

Light My Bricks: Ninjago City Lighting Kit

Package contents:
11x White Strip Lights
2x Blue Strip Lights
3x White 30cm Bit Lights
13x White 15cm Bit Lights
3x Flashing White 30cm Bit Lights
4x Pink 30cm Bit Lights
2x 12-Port Expansion Board
2x 6-Port Expansion Boards
3x 30cm Connecting Cables
11x 15cm Connecting Cables
2x 5cm Connecting Cables
8x Adhesive Squares
1x Battery Pack (requires 3x AA Batteries)
OR
1x USB Power Cable
Note – Battery Pack will be replaced with USB Power Cables from mid April
2020
LEGO Pieces
10x LEGO Plate 1×6 (any colour)
1x LEGO Plate 1×8 (Dark Bluish Grey)
Important things tonote:
Laying cables in between and underneath bricks


Cables can t in between and underneath LEGO® bricks, plates, and tiles providing
they are laid correctly between the LEGO® studs. Do NOT forcefully join LEGO®
together around cables; instead ensure they are laying comfortably in between each
stud.


Connecting cable connectors to Expansion Boards
Take extra care when inserting connectors to ports of Expansion Boards. Connectors
can be inserted only one way. With the expansion board facing up, look for the
soldered “=” symbol on the left side of the port. The connector side with the wires
exposed should be facing toward the soldered “=” symbol as you insert into the port.
If a plug won’t t easily into a port connector, do not force it.
CAUTION: Forcing LEGO® to connect over a cable can result in damaging
the cable andlight.
“




Connecting cable connectors to StripLights
Take extra care when inserting connectors to ports on the Strip Lights. Connectors
can be inserted only one way. With the Strip Light facing up, ensure the side of the
connector with the wires exposed is facing down. If a plug won’t t easily into a port
connector, don’t force it. Doing so will damage the plug and the connector.
Incorrectly inserting the connector can can result in bent pins inside the
port or possible overheating of the expansion board when connected.
“


Installing Bit Lights under LEGO® bricks andplates.


When installing Bit Lights under LEGO® pieces, ensure they are placed the correct
way up (Yellow LED component exposed). You can either place them directly on top
of LEGO® studs or in between.


OK, Let’s Begin!
Instructions for thisKit 

1.) Start by removing the roof, third, and fourth oors.
