Lightmybricks LEGO Big Ben Lighting Kit User manual

Light My Bricks : LEGO Big Ben
Lighting Kit
Jun 11, 2017
Here is the instructions document for the LEGO Big Ben LED lighting
kit. Please read and follow the steps carefully to ensure this lighting kit
is installed properly.
Package contents:
 6x White Strip Lights
 2x Green Strip Lights
 17x White 15cm Bit Lights
 3x White 30cm Bit Lights

 2x 6-Port Expansion Boards
 2x 8-Port Expansion Boards
 5x 5cm Connecting Cables
 4x 15cm Connecting Cables
 1x 30cm Connecting Cable
 1x 50cm Connecting Cable
 16x Adhesive Squares
 1x AA Battery Pack (requires 3x AA Batteries)
LEGO Pieces
 9x Plate 1x6, Black
 6x Plate, Modified 1x2 with handle on End — Close Ends, Black
 6x Tile, Modified 1x1 with Clip, Black
 2x Tile 1x1, Dark Grey
Important things to note:
Laying cables in between and underneath bricks
Cables can fit in between and underneath LEGO® bricks, plates, and
tiles providing they are laid correctly between the LEGO® studs. Do
NOT forcefully join LEGO® together around cables; instead ensure
they are laying comfortably in between each stud.

CAUTION: Forcing LEGO® to connect over a
cable can result in damaging the cable and light.
Connecting cable connectors to Strip Lights
Take extra care when inserting connectors to ports on the Strip Lights.
Connectors can be inserted only one way. With the Strip Light facing
up, ensure the side of the connector with the wires exposed is facing
down. If a plug won’t fit easily into a port connector, don’t force it.
Doing so will damage the plug and the connector.

Connecting cable connectors to Expansion Boards
Take extra care when inserting connectors to ports of Expansion
Boards. Connectors can be inserted only one way. With the expansion
board facing up, look for the soldered “=” symbol on the left side of the
port. The connector side with the wires exposed should be facing

toward the soldered “=” symbol as you insert into the port. If a plug
won’t fit easily into a port connector, do not force it.
WARNING: Incorrectly inserting the connector
can result in bent pins inside the port or possible

overheating of the expansion board when
connected.
Installing Bit Lights under LEGO® bricks and plates.
When installing Bit Lights under LEGO® pieces, ensure they are
placed the correct way up (Yellow LED component exposed). You can
either place them directly on top of LEGO® studs or in between.

OK, Let’s Begin!
Instructions for installing this kit
1.) We will first install lights to clock tower. To start, disconnect the the
top part of the tower from where the bottom of the clock is.