Lightolier Lytecaster 402MRX User manual

07-02
4 3/4" (121mm) aperture Lytecaster
Low Voltage MR16 12V Recessed Downlight
Standard Frame-In-Kit (Non-IC)
Complete fixture consists of Reflector Trim & Frame-in Kit. Select each separately
POWER PACK CUT-OUT
402MRX 4 3/4" (121mm) Accepts all 4 3/4" (121mm) Low Voltage MR16 trims 400 series: see
Reflector Trim specification sheets.
Features Accessories
Mounting Frame : 20ga. galvanized steel. Four slots are positioned 90º Mounting Bars Extenders : 1964
apart to simplify alignment. 20" (508mm) long. Set of 2
Mounting Bars: (4) 18 ga. galvanized steel. 13" (330mm) long bars extend to
27" (686mm), rotatable and lockable, integral T-bar tabs. Spike detail Mounting Bar Locking Clips : 0098
eliminates the need of additional nailing. To lock mounting bars in place after installation. Set of 12.
Mounting Bars Locking Clip : (1) locks mounting bars in place.
Snap-on Socket Cup : 22ga. galvanized steel. Easy snap-on to housing.
Socket : Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon
250º leads to junction box.
Transformer : 75VA Magnetic, 120 volt primary, nominal 12 volt secondary,
class "H".
Thermal Protector : Meets CSA/UL requirements. Insulation, if used, must
be kept 3" (76mm) away from luminaire sides and junction box.
Junction Box : 4"(102mm) x 3"(76mm) x 2"(51mm) 18 ga. galvanized steel .
CSA/UL certified for maximum of 8 No. 12 ga. 90º C through branch circuit
conductors. Integral cable clamp permit attachment of non metallic Loomex Labels : CSA , UL
without need of additional connectors. Pry-out knock-outs accept BX cable.
Easy access from both sides with snap-on covers. Damp or Wet location rated depending on trim used.
WE RESERVE THE RIGHT TO CHANGE DETAILS OF DESIGN, MATERIALS AND FINISH, IN ANY WAY
THAT WILL NOT ALTER INSTALLED APPEARANCE OR REDUCE FUNCTION AND PERFORMANCE.
Lightolier CFI, 3015 Louis Amos Lachine, (Quebec) H8T 1C4
REFLECTOR TRIM
402MRX