Lightolier 9” PENDALYTE SERIES Instruction Manual

SOCKET
CANOPY ASSEMBLY
BOTTOM PLATE
SPACE NECK
KEYSLOTS
REFLECTOR
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:40411
1198 Page 1 of 1
STUD
WIRE NUTS
CROSSBAR
1. Thread STUD into CROSSBAR as shown (fig.1).
2. Using appropriate slots in CROSSBAR, secure
CROSSBAR to OUTLET BOX using OUTLET BOX
SCREWS (provided with OUTLET BOX).
3. While supporting CANOPY ASSEMBLY make
connections: black POWER CORD lead to hot (black)
supply lead; white POWER CORD lead to neutral
(white) supply lead. Green POWER CORD wire is a
ground wire and must be connected to grounding
terminal or ground lead inside OUTLET BOX. Use
WIRE NUTS (local hardware item). Push supply wires
and connections back into OUTLET BOX.
4. Tighten SET SCREW into STRAIN RELIEF BUSHING
to secure POWER CORD.
CAUTION: MAKE CERTAIN WIRES ARE NOT
PINCHED BETWEEN PARTS.
5. Place STUD through hole in CANOPY and thread
ADJUSTING COLLAR onto STUD securing CANOPY
ASSEMBLY against ceiling.
POWERHEAD INSTALLATION:
1. Remove DOOR from POWERHEAD by removing
screw (labled open) in top mounting plate. Pull
door directly away from powerhead.
2. Height Adjustment: To raise fixture, push CABLE
down into HANGER FITTING. If necessary, push
excess POWERCORD down into POWERHEAD.
(Make certain CABLE does not interfere with internal
wiring or components, both POWERCORD and
CABLE may be cut inside POWERHEAD.) To lower
fixture, push down on PLUNGER and allow fixture to
drop to desired height.
3. If necessary, cut excess CABLE from inside
POWERHEAD.
4. Using wire nuts (local hardware item) wire fixture:
Black fixture lead to hot (black) POWERCORD lead;
white fixture lead to neutral (white) POWERCORD
lead. Attach green ground wire from BOTTOM PLATE
to green ground wire from POWERCORD and ballast
(if supplied).
5. Reinstall door and secure in place by tightening SCREW
through TOP MOUNTING PLATE.
6. Install recommended lamp(s).
CAUTION: MAXIMUM WATTAGE AS MARKED ON
FIXTURE MUST NOT BE EXCEEDED.
REFLECTOR INSTALLATION:
1. To secure REFLECTOR to SPACER NECK, position
MOUNTING SCREWS through KEYSLOTS and twist
REFLECTOR counter-clockwise. Secure REFLECTOR
in position by tightening MOUNTING SCREWS.
INSTRUCTION SHEET FOR ASSEMBLY AND INSTALLATION OF 9” PENDALYTE™SERIES
MOUNTING SCREW
CABLE
PLUNGER
HANGER
FITTING POWERHEAD
OUTLET BOX
SET SCREW
COLLAR
DOOR
POWERCORD
SCREW
TOP MOUNTING
PLATE
STRAIN RELIEF
BRUSHING
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
OUTLET BOX SCREW
CABLE
FIG. 1