Lightolier Lytecaster 1000LVE User manual

Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • [phone] • Fax [phone]
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • C1208
Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lytecaster®Recessed Downlighting 1000LVE
Page 1 of 1 5" Aperture Electronic Low Voltage MR16 Incandescent Frame-In Kit
Features
1. Mounting Frame: .036" (#20 ga.) galvanized steel. Accommodates all
ceilings up to 1" thick; including existing or inaccessible areas. Breakout
section and anchor nails permits installation in existing ceilings from below.
Push-in/twist-out rotoclips hold reflector flush to ceiling.
2. Junction Box: 4" x 3 1/2”x 2", .063" (#14 ga.) galvanized steel. U.L. listed for
maximum of 8 No. 12 ga. 90° C through branch circuit conductors (1000LVE2
only). Integral cable clamps permit attachment of nonmetallic Romex®or
armored cable without need of additional connectors.
3. Mounting Bars: .059" (#16 ga.) galvanized steel. 13" long bars extend
to 27" with integral nailing tabs. Attaches to wood joist without need of
accessories.
4. Socket Housing: .036" (#20 ga.) galvanized steel.
5. Socket: Field replaceable. Two pin socket, pre-wired with #18 SF1 leads to
junction box.
6. Thermal Protector: Meets NEC and UL requirements. Insulation must be
kept 3" away from fixture sides and wiring compartments and must not be
placed above fixture in a manner which will entrap heat.
7. Transformer: Outboard mounted, Electronic, 120V (1000LVE1), 277V
(1000LVE2)primary, nominal 12V secondary. Removable from below.
Dimming
Dimming Controls: Use only dimmers specifically designed for use with elec-
tronic transformers. Consult Lightolier Controls for more information. Low volt-
age luminaires may produce audible sound when used with dimmers, which may
be objectionable in acoustically critical areas.
Options & Accessories
Mounting Bars: 1964 - 20" set of (2)
T-Bar Ceiling Clips: 1956 - set of (4)
Options & Accessories (continued)
Plaster Ceiling Ring: 1960 - 7/8" depth for wet plaster ceilings.
Extra-Thick Ceiling
Mounting Ring: 1967B - up to 2" thick ceilings.
MR16 Socket Replacement: 1975B
Remodeler Anchor Clip: 1985N
Labels
UL (Suitable for Damp Locations), I.B.E.W.
Romex® is a registered Trademark of General Cable Industries Inc.
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit Reflector Trims — See Individual Reflector Trim Specification Sheets
Adjustable
1000LVE1 Baffles Aperture Cone Pinhole Elbow
120V- 0.67A Max 1055LV 1056LV 1064WDLV 1052LV 1062LV
1055WHLV 1063LV 1064WDPLV
1000LVE2 1064LV
277V- 0.27A Max 1064CDLV