Lightolier Round Calculite User manual

IS7790
RETAINER RING R0692
Page 2of 2
c.
D.
TO REVERSE TRIM FRAME
Disenaaae TRIM FRAME from RETAINER by
forcin~ ~small screwdriver into space between
TRIM FRAME and RETAINER near one of
BOSSES and pry out. Repeat near the other
two BOSSES until TRIM FRAME is free.
Reverse TRIM FRAME and snap it back over
RETAINER until RETAINER’S lip falls into
space between upper and lower BOSSES.
TO INSTALL AND WIRE FIXTURE
1.Wire to supply leads. White fixture lead to
neutral supply lead. Black fixture lead to hot
(120V.) supply lead. Bare fixture wire to supp-
ly ground. Use wirenuts (local hardware
items). Place all electrical connections in the
J-BOX. Attach J-BOX COVER onto J-BOX.
2.To insure aneat installation, keep LENS
BEZEL in carton; insert paint shield in DUO-
CAST REVERSIBLE TRIM FRAME to protect
inside of fixture from paint, plaster and dust.
Remove after construction is complete.
3. Adjust fixture for correct wattage. This fixture
is set at the factory for the smallest lamp
size. For other lamp sizes as desired (see ar-
chitect’s or engineer’s plans). Compress RE-
TAINING SPRING and push ADJUSTABLE
SOCKET HOUSING upward until RETAINING
SPRING engages to slot for the required
lamp/wattage position. (See Fig. 4 and 5.)
4.Set DUO-CAST REVERSIBLE TRIM FRAME
for flange or flangeless installation in accor-
dance with Step A.
5.After ceiling is completed, attach LENS
BEZEL by squeezing TORSIONTITE SPRINGS
together and insert through slots in housing;
push up to ceiling.
6.To attach LENS BEZEL, squeeze TORSION-
TITE SPRINGS together and insert through
slots in housing (Fig. 3); push up to ceiling.
7.To relamp, simply push lens up and grip
edge of bezel. Then pull down (Fig. 6).
VERSIBLE
DUO-CAST-
REVERSIBLE
TRIM FRAME
n
LENS BEZEL .-
FIG. 3
;:TT;;T
LAMPIWATTAGE
POSITION LABEL
M
..
(INSIDE NECK) .
LAMP/WAITAG E
POSITION MARKING $
(OUTSIDE NECK)
FIG. 4
OPTICAL
SECTION
J&FINGER
HOLE
RETAINING
SPRING
/
FIG. 6TO RELAMP FIG. 5