lumishore Shorelite X18 User manual

Shorelite X18 / X36 / X90 Installation Guide
DOC NO: LSIN-09-010A
Shorelite x18 / x36 / x90 Installation Guide
Important –Please read Individual Product Instructions carefully before installation.
General Safety Information:
Please consider these safety precautions carefully before proceeding with the installation.
High Intensity LED light –Do not stare into the led module at close proximity.
All installation should be carried out by a qualified professional, to ensure installation with the
utmost care and caution. If in doubt please contact Lumishore ltd.
The Shorelite electronics have been designed to be 12V DC only. Always ensure that you have
the correct module for your power supply prior to installation and under no circumstances
connect a unit directly to the mains voltage.
Always ensure that the shore power source and / or battery are disconnected or isolated prior
to installation.
Always use a suitable fuse or circuit breaker.
The Lumishore Shorelite has been designed as an underwater light module. Please note that
running the device out of water for more than 60 seconds will cause the device to become hot
and switch itself off.
Warning: DO NOT OPERATE THE SHORELITE OUT OF WATER FOR MORE THAN 60 SEC.

Shorelite X18 / X36 / X90 Installation Guide
DOC NO: LSIN-09-010A
Where to attach the Lumishore Shorelite:
The Lumishore Shorelite has been designed to either be directly attached to a wall or pontoon or used in
conjunction with the Shorelite maintenance arm that allows for easier inspection and cleaning. Please contact
Lumishore for more information.
Electrical Connection:
NOTE: FOR MAXIMUM LIGHT OUTPUT AND EFFICIENCY THE SHORELITE SHOULD BE SUPPLIED WITH A VOLTAGE
WITHIN THE RANGE OF 12-14 Volts.
A Shorelite will continue to work below 12 Volts although light output power will be considerably reduced. When
choosing a suitable power supply, cable run length, cable gauge and voltage drop should be considered to ensure
each Shorelite is operating within the correct voltage range.
For Installation convenience the end of each cable has been colour coded as follows...
Red wire (cable laser marked “1”) = Positive Voltage (12Volt DC)
Black wire (cable laser marked “2”) = Ground (0 Volts)
How to Maintain the Lumishore Shorelite.
Lumishore recommends general inspection of the Shorelite module and cable attachments every month.
The glass lens should be kept clean with a plastic scraper or soft brush. Regular cleaning of the lens will
ensure that the Shorelite delivers maximum light output.
To prolong device lifetime and maintenance schedules, an anti foul solution such as Prop Speed can be
used to help prevent marine growth.
Warranty Information. For full warranty information please consult www.Lumishore.com
Lumishore Ltd warrants the Shorelite to be free from defects in workmanship and materials for a period of 2 years starting from
the date of original purchase. Misuse, abuse, improper installation, neglect, improper shipping, damage caused by disasters
such as fire, flood and lightening, installation but unqualified personnel, unauthorised repair or modification will void this
warranty. Should your Shorelite be defective during this period, please contact your dealer in the first instance as soon as you
become aware of the defect.
Model (All Colours)
MAX Current Per Device (Amps)
SHORELITE X18, 12 Volt
1.5 Amps
SHORELITE X36 12 Volt
3 Amps
SHORELITE X90 12 Volt
7.5 Amps