Lutron Electronics GRAFIK 6000 User manual

NT-DMXJ-IN
Theatrical Stageboard Receptacle
(Class 2/PELV Device)
Installation
DANGER! Always turn off the power to the con-
trol panel before doing any work. Failure to do
so can result in serious personal injury and
damage to equipment.
1. Prewiring: The Control Links require special wiring consider-
ations. Refer to the User's Guide and Lutron job drawings for
wiring restrictions and limitations that apply to your specific
project.
2. Turn power OFF.
3. Separate faceplate from faceplate adapter by pulling from the
center of the top of the faceplate. Unscrew faceplate adapter
and set aside.
4. Strip insulation from wires so 3/8" bare wire is exposed. This
device does not get an address and does not count as one of
the 32 controls allowed on the Control Link.
5. Connect wiring as shown on the following page and confirm
all connections.
6. Mount device as shown in the Mounting Diagram using the
mounting screws provided. Screw on faceplate adapter and
snap on faceplate.
7. Restore power to the control panel after the installation of
the system is complete.
Description
The NT-DMXJ Theatrical Stageboard Receptacle allows a Lutron
Grafik 6000 Lighting Control System to connect to and control a
theatrical stage board. The receptacle features a five-pin XLR style
male jack for connecting Link B* of the Circuit Selector to a
theatrical stage board and provides a standard DMX-512 pinout
(theatrical protocol).
* If DMX is the primary communications protocol, the NT-DMXJ Receptacle
may also connect to Link A of the Circuit selector. Please contact Lutron for
more information regarding this configuration.
Important Notes
1. READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING
INSTALLATION.
2. This device must be installed by a qualified electrician.
3. Install in accordance with the National Electric Code®and all
applicable local regulations.
4. Turn power OFF at the control panel before installing the
device. Do not connect high-voltage power to low voltage
terminals. Improper wiring can result in personal injury or
damage to the control or to other equipment.
Mounting Diagram
Installation Instructions
Please Leave for Occupant
Walljack Mounting Screws
Adapter Mounting
Screws
Standard U.S. Wallbox
Walljack
Faceplate Adapter
Faceplate
®
0.875 in.
(22.2 mm)
0.385 in.
(9.8 mm)
0.285 in.
(7.2 mm)
STAGEBOARD
RECEPTACLE
2.72 in. (69 mm)
4.57 in.
(116.1 mm)

Lutron Electronics Co., Inc.
Made and printed in U.S.A. 3/03
P/N 030-813 Rev. A
FRANCE
Lutron LTC
International ++33-(0)1-44-70-71-86
Int’l Fax: ++33-(0)1-44-70-70-97
ASIAN HEADQUARTERS
Lutron Asuka Co., Ltd. (Japan)
Tel: [phone];
International ++81-3-5575-8411
Fax: [phone];
International ++81-3-5575-8420
HONG KONG SALES OFFICE
Lutron GL (Hong Kong)
Tel: [phone];
International ++852-2104-7733
Fax: [phone];
International ++852-2104-7633
SINGAPORE
Lutron GL (Singapore)
Tel: ++65-220-4666
Fax: ++65-220-4333
Internet: www.lutron.com
E-mail: [email protected]
WORLD HEADQUARTERS
Lutron Electronics Co. Inc.,
TOLL FREE: [phone]
(U.S.A., Canada, Caribbean)
Tel: [phone];
International ++1- 610-282-3800
Fax: [phone];
International ++1-610-282-1243
GREAT BRITAIN
Lutron EA Ltd.,
Tel: [phone];
International ++44-(0)207-702-0657
Fax: [phone];
International ++44-(0)207-480-6899
GERMANY
Lutron Electronics GmbH
Tel: [phone];
International ++49-30-97-10-4590
Fax: [phone];
International ++49-30-97-10-4591
LIMITED WARRANTY
Lutron will, at its option, repair or replace any unit that is defective in materials or manufacture with-
in one year after purchase. For warranty service, return unit to place of purchase or mail to Lutron at
7200 Suter Rd., Coopersburg, PA 18036-1299, postage pre-paid.
This warranty is in lieu of all other express warranties, and the implied warranty of
merchantability is limited to one year from purchase. This warranty does not cover the
cost of installation, removal or reinstallation, or damage resulting from misuse,
abuse, or improper or incorrect repair, or damage from improper wiring or installation.
This warranty does not cover incidental or consequential damages. Lutron’s liability
on any claim for damages arising out of or in connection with the manufacture, sale,
installation, delivery, or use of the unit shall never exceed the purchase price of the
unit.
Thiswarrantygivesyouspecificlegalrights,andyoumayalsohaveotherrightswhichvaryfromstate
tostate.Somestatesdonotallowlimitationsonhowlonganimpliedwarrantylasts,sotheabovelim-
itation may not apply to you. Some states do not allow the exclusion or limitation of incidental or con-
sequential damages, so the above limitation or exclusion may not apply to you.
This product may be covered under the following U.S. patent: 4,835,343 and corresponding foreign
patents.
Nomex is a registered trademark of E.I. Du Pont de Nemours and Company.
National Electrical Code is a registered trademark of National Fire Protection Association.
Lutron, and GRAFIK 6000 are registered trademarks, and 2Link is a trademark of Lutron Electronics Co. Inc.
© 2003 Lutron Electronics Co., Inc.
SELECT CIRCUIT
2
1
Circuit
Data A OK Power
1234 5D
Common 24VFW
MUX MUX Drain
Sense
1234D5
Data B OK
B
Comm Drain
MUX MUX
CD
Link
A
Link
CD
STAGEBOARD
RECEPTACLE
Circuit Selector in the GP Panel
To next panel
Typical Wiring: DMX to Link B (2Link™only)
Wires must be daisychained and capped off at both ends of Link B.
DMX Cable Type
Belden 9729/89729:
Duraflex 22/4WS:
OR
Lutron
GRX-CBL-DMX-250/500:
CD
Common (Pin 1)
DMX+ (Pin 3) DMX– (Pin 2)
Wire
(2) drain/shield
white
black
black
red
(2) drain/shield
white
black
green
red
From
Circuit Selector
C
+
–
No Connect
No Connect
C
+
–
No Connect
No Connect
DMX Cable Wiring Table
To DMX Jack
(Pin #)
C (1) (white/black)
+ (3)* (yellow)
– (2)* (red)
– (4) (blue)
+ (5) (black)
C (1) (white/black)
+ (3)* (yellow)
– (2)* (red)
– (4) (blue)
+ (5) (black)
* Wire in daisy-chain configuration as follows: Cto C, +to +, and –to –.
NT-DMXJ-IN Stage Board
DMX Cable
(see chart below)