Mainstays MS18-D2-1011-05 User manual

THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Date 2018-02-25 Rev. 0001-A Factory: DOTEHA
Beckett Kids Metal Rolling Student Desk
Stock # MS18-D2-1011-05
ADULT ASSEMBLY REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our customer service number and have your instructions
and parts list ready to provide the model name, part name or factory number:
866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday
Or visit our web site 24 hours a day, 7 days a week for product assistance at
www.whalenstyle.com
Or e-mail your request to [e-mail]
LOT NUMBER:
DATE OF PURCHASE:
/
/

2
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Desk Top (Qty. 1)
B- Top Metal Frame (Qty. 1)
C- Left Leg (Qty. 1)
D- Right Leg (Qty. 1) E- Stretcher (Qty. 1)
F- Locking Caster (Qty. 2)
G- Swivel Caster (Qty. 2)
(1) 1/4" x 5/8” Bolt (Qty. 14+1 extra) (2) Lock Washer (Qty. 12+1 extra)
(3) Flat Washer (Qty. 12+1 extra) Hex Wrench (Qty. 1) Open Wrench (Qty. 1)
Tools required: Hex wrench and open wrench (provided).

3
ASSEMBLY INSTRUCTIONS
NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back
and fully tighten all bolts. This will make the assembly easier.
1. Unpack the units and confirm that you have all hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Attach the Stretcher (E) between the Legs (C and D) with two 5/8” Bolts (1).
UP
1
C / D
C
D
E
E
1/4" x 5/8” Bolt
(2 used in this step)
①

4
ASSEMBLY INSTRUCTIONS
3. Stand the assembled unit upright.
4. Attach the Top Metal Frame (B) to the Legs (C and D) with four 5/8” Bolts (1) and four Washers (2 and
3).
C
D
B
1
2
3
C / D
B
Lock Washer
(4 used in this step)
②
Flat Washer
(4 used in this step)
③
1/4" x 5/8” Bolt
(4 used in this step)
①

5
ASSEMBLY INSTRUCTIONS
5. Flip last assembly and attach the Top Metal Frame (B) to the Desk Top (A) with eight 5/8” Bolts (1)
and eight Washers (2 and 3).
1
2
3
A
B
B
A
Lock Washer
(8 used in this step)
②
Flat Washer
(8 used in this step)
③
1/4" x 5/8” Bolt
(8 used in this step)
①

6
ASSEMBLY INSTRUCTIONS
6. Securely fasten the Casters (F and G) onto the bottom of Legs (C and D). Be sure the Locking Casters
(F) are located on the same short end.
NOTE: Set the brake on the locking casters unless you are moving the desk.
7. Ask for assistance to stand the assembled unit upright and position it at the desired location.
D
C
G
G
F
F

7
Care and Maintenance
For everyday cleaning, chrome, brass, aluminum, and painted metal surfaces can be kept looking their best
by wiping with a slightly damp, soft cotton cloth or vacuum cleaner brush.
If soiled, wipe with clean sponge or cloth wrung out of water. Wipe dry with cloth or paper towel to avoid
water spots.
Do not use any harsh abrasives or chemicals to clean any metal surfaces as it may damage the protective
coating.
Metal will rust if the finish is scratched or if your furniture is exposed to excessive humidity, particularly in
salt water locations.
Most metal furniture has a protective coating to prevent rust, however rust may occur if the finish is marred
or wears away over time.
In the event that your furniture is stained or otherwise damaged during use, we recommend that you call a
professional to repair your furniture.
Check bolts/screws periodically and tighten them if necessary.
Further Advice about Metal Furniture Care
It is best to keep your furniture in a climate controlled environment. Continual exposure to damp and wet
environment can cause corrosion. It is advised to keep furniture away from direct sunlight as it may damage the
finish. Indoor furniture is not recommended for outdoor use.
Proper care and cleaning at home will extend the life of your purchase. Following these important and helpful
tips will enhance your furniture as it ages.
We hope you enjoy your purchase for many years.
Thank you for your purchase!
QUALITY GUARANTEE
We are confident that you will be delighted with your Whalen Furniture purchase.
Should this product be defective in workmanship or materials or fail under normal use, we will repair
or replace it for up to one (1) year from date of purchase. Every Whalen Furniture product is designed
to meet your highest expectations. We guarantee that you will immediately see the value of our fine
furniture.
This warranty gives you specific legal rights and you may also have other rights which vary from State
to State.
Customer Service: 866-942-5362
8:30 a.m. - 4:30 p.m., PST, Monday to Friday
www.whalenstyle.com

ESTE INSTRUCTIVO CONTIENE INFORMACION IMPORTANTE DE SEGURIDAD.
POR FAVOR LEA Y MANTENGA PARA USO FUTURO.
Fecha 2018-02-25 Rev. 0001-A Fábrica: DOTEHA
Escritorio de metal Beckett para niños
Serie # MS18-D2-1011-05
ENSAMBLE REQUERIDO POR ADULTO
Si tienen alguna pregunta acerca del ensamble o si alguna parte está faltante, no retorne esté producto
a la tienda donde lo compró. Por favor llame a nuestro departamento de ayuda al cliente teniendo su
instructivo y lista de partes para proveer el modelo, nombre de parte o el número de fábrica:
866-942-5362
Hora estándar del Pacífico: 8:30 a.m. - 4:30 p.m., de Lunes a Viernes
O visite nuestra página de Internet 24 horas al día, 7 días a la semana para asistencia
www.whalenstyle.com
O mande un correo electrónico a [e-mail]
NÚMERO de LOTE:
FECHA de COMPRA
:
/
/

2
Lista de partes y material de ferretería
Por favor lea completamente las instrucciones y verifique que estén todas las partes antes de iniciar el
ensamblado.
A- Tapa de escritorio (Cant. 1)
B- Marco de metal superior (Cant. 1)
C- Pata izquierda (Cant. 1)
D- Pata derecha (Cant. 1) E- Soporte (Cant. 1)
F- Rueda con bloqueo (Cant. 2)
G- Rueda s/bloqueo (Cant. 2)
(1) Perno de 1/4" x 5/8” (Cant. 14+1 extra) (2) Arandela de presión (Cant. 12+1 extra)
(3) Arandela plana (Cant. 12+1 extra) Llave hexagonal (Cant. 1) Llave española (Cant. 1)
Herramientas requeridas: Llave hexagonal y llave española (provistas).