MakerBot FILAMENT CASE User manual

The MakerBot Filament Case allows for convenient
storage and use of MakerBot XL and XXL spools
with the MakerBot®Replicator®Z18 3D Printer.
THE MAKERBOT®
FILAMENT CASE

IMPORTANT SAFETY INFORMATION
Carefully read all instructions before use. Keep these instructions for future reference.
Caution: When using the Filament Case in conjunction with the MakerBot Cart for the
MakerBot Replicator Z18, avoid leaving the Filament Case empty and open on the cart
shelf. The case could fall and break.
PARTS LIST
Note: MakerBot XXL filament spool
ships separately.
MakerBot Filament Case
1
Guide tube adapters
2
Filament guide tubes
2

ASSEMBLY INSTRUCTIONS
Note: Ensure filament
winds over the top of
the spool.
3. REMOVE THE SPOOL AXLE FROM THE
MAKERBOT FILAMENT CASE AND LOAD
A FILAMENT SPOOL.
4. INSERT A FILAMENT GUIDE TUBE INTO
ONE OF THE GUIDE TUBE ADAPTERS.
1. INSERT THE GUIDE TUBE ADAPTERS INTO
THE GROMMETS ON THE FILAMENT CASE.
2. OPEN THE CASE BY DEPRESSING
THE LATCH.
5. ROUTE FILAMENT THROUGH THE
GUIDE TUBE.
6. INSERT THE LOOSE END OF THE GUIDE
TUBE INTO THE PORT AT THE TOP LEFT
SIDE OF THE MAKERBOT REPLICATOR Z18.

www.makerbot.com