Marcy SR50 User manual

NOTE:
Please read all instructions
carefully before using this
product
Safety Notice
Assembly Instruction
Exploded Diagram
Parts List
Warranty
Ordering Parts
Model
SR50
Retain This
Manual for
Reference
160826
OWNER'S
MANUAL
MARCY SQUAT RACK
SR50

TABLE OF CONTENTS
BEFORE YOU BEGIN..................................................................................... 1
IMPORTANT SAFETY NOTICES.................................................................... 2
ASSEMBLY INSTRUCTIONS..........................................……………………… 3
EXPLODED DIAGRAM…………………………………………………………….. 4
PARTS LIST………..………………………………………………………………. 5
WARRANTY.................................................................................................… 6
ORDERING PARTS......................................................................................... 6
BEFORE YOU BEGIN
Thank you for selecting the MARCY SQUAT RACK SR50. For your safety
and benefit, read this manual carefully before using the machine. As a
manufacturer, we are committed to provide you complete customer
satisfaction. If you have any questions, or find there are missing or damaged
parts, we guarantee you complete satisfaction through direct assistance from
our factory. To avoid unnecessary delays, please call our Customer
Solutions Department. Monday to Friday 8am to 5pm GMT.
Pure-Tec Limited
Tel: [phone]
Monday - Friday 0800 – 1700 GMT
www.puretecfitness.com
[e-mail]
1

IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire
manual before you assemble or operate your machine. In particular, note the following
safety precautions:
1. Keep children and pets away from the machine at all times. DO NOT leave
children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT
YOUR DOCTOR. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER
THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS.
READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT.
PURE-TEC LIMITED ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY
OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS
PRODUCT.
SAVE THESE INSTRUCTIONS.
2

ASSEMBLY INSTRUCTION
Tools Required Assemble The Machine:
Two Adjustable Wrenches
STEP 1 (See Diagram 1)
A.) Attach the Support Frame (#2) to the Upright Beam (#1).Secure the top with two
M10×3" Bolt (#10), one Long Bracket (#3), four Ø 7/8” Washers (#12), and two M10
Nuts (#13). (Do not tighten the nuts and bolts yet.) Attach one short Bracket (#4) to
Upright Beam (#1). Secure it with one M10×3 1/4" Bolt (#9), one M10×3" Bolt (#10),
three Ø 7/8” Washers (#12), and one M10 Nut (#13).
B.) Repeat the above step A to install the other Upright Beam to the Support Frame.
C.) Securely tighten all the nut and bolts previously installed. Insert two Bar Catches
(#6)&(#7) to the desired holes at the same height.
3

EXPLODED DIAGRAM
4

Parts list
KEY NO. DESCRIPTION Q’ty
1 Upright Beam 2
2 Support Frame 1
3 Long Bracket 2
4 Short Bracket 2
5 Chrome Plate 2
6 Right Bar Catch 1
7 Left Bar Catch 1
8 Square End Cap 6
9 M10×3 1/4" Bolt 2
10 M10×3" Bolt 6
11 Screw 6
12 Ø 7/8” Washer 14
13 M10 Nut 6
14 φ25 End Cap 2
5

LIMITED WARRANTY
Pure-Tec warrants this product to be free from defects in workmanship and material, under normal
use
and service conditions, for a period of two years on the frame and one year on all other parts
and components from the date of purchase. This warranty extends only to the original purchaser.
Pure-Tec’s
obligation under this Warranty is limited to replacing damaged or faulty parts at Pure-Tec’s
option.
All returns must be pre-authorised by Pure-Tec. This warranty does not extend to any product or
damage
to a product caused by or attributable to freight damage, abuse, misuse, improper or
abnormal
usage, purchasers own repairs or for products used for commercial or rental purposes. No
other
warranty beyond that specifically set forth above is authorized by Pure-Tec.
Pure-Tec is not responsible or liable for indirect, special or consequential damages arising out of
or in connection with the use or performance of the product or other damages with respect to any
economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal,
installation
or other consequential damages or whatsoever natures.
The warranty extended hereunder is in lieu of any and all other warranties and any implied
warranties of merchantability or fitness for a particular purpose is limited in its scope and duration to
the
terms set forth herein.
Your statutory rights are not affected.
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Solutions Department Monday to
Friday 8am to
5 pm GMT.
Pure-Tec Limited
Tel: [phone]
Monday - Friday 0800 – 1700 GMT
www.puretecfitness.com
[e-mail]
When ordering replacement parts, please give the following information.
1. Model
2. Description of Parts
3. Part Number
4. Date of Purchase
6