Marquee ORIENTAL LEAN TO WALL GAZEBO User manual

ORIENTAL LEAN TO WALL GAZEBO
Assembly Instructions
Item number:0178005

Leg tube
Leg tube
Ring beam
Roof tube
Roof tube
Roof tube
Roof tube
Roof tube
Roof tube
Roof tube
Foot plate
Allen key
Spanner
Stake
Canopy
Bolt
Nut
Bolt
Bolt

Insert the foot plate(E) into the leg tube(A1) and align the hole.
Insert the foot plate(E) into the leg tube(A2) and align the hole.

Connect the ring beam (B) to the leg tube (A1) using bolt (I) and
nut (J). Tighten securely using Allen Key (L) and Spanner (M).
The exposed hole on the ring beam (B) should be facing up.
The exposed hole on the ring beam (B) should be facing up.
Connect the ring beam (B) to the leg tube (A2) using bolt (I) and
nut (J). Tighten securely using Allen Key (L) and Spanner (M).

Connect the roof tube (C1) and leg tubes (A1 & A2) using bolt (I) and nut (J). Tighten
securely using Allen Key (L) and spanner (M).
Attach two of the roof tubes (C3) to the ring beam (B), as pictured
using bolts (G).

Slide the tubes from the centre of the gazebo to the outer edge.
Attach another roof tube (C3) to the ring beam (B), as pictured using
bolts (G).

Insert the roof tubes
(D1 & D3) into the third
roof tube (C3) and
connect into the
corresponding tubes
(D2 & D4). Secure
these using bolt (H) -
refer to image.
Complete the frame assembly by connecting roof tube (D1 & D3) with roof tube
(C2) and leg tube (A1 & A3). Secure using bolt (I) and nut (J). Tighten with Allen
Key (L) and spanner (M).

Secure all the roof tubes at the edges (C1 & C2) using bolts (G)
as pictured. Tighten with Allen Key (L).
Cover the gazebo frame with the canopy (F). Use bolts (G) to secure the corners
of the canopy with the frame.

Once you have located your gazebo in the desired location you can secure the
gazebo down by inserting the stakes (K) through the foot plate (E) and into the
ground. Your gazebo is now ready for use.