Martin System Tiny Trainer TT1000 User manual

FINGER KICK
User’s guide

Congratulations
You have just bought the perfect accessory which will help you
throughout the education and the life of your dog.
Thanks tothis Hand Free Kit, you attend to your affairs keeping
the control of your dog.
This user's guide explainshow to use the "Finger Kick" with the
compatible remote.
The "Finger Kick" uses the transmitter as relay.
Thanks to the unique code given to the remote, it is strictly
impossible to have interferences with similar equipment, or other
transmitter used by a neighbour.
The "Finger Kick" has been successfully tested in extreme used
conditions (from -20°C to +60°C, as well as in the air than in the
water).

Compatibility
The "Finger Kick" is compatible with the following remotes:
TinyTrainer range:
•TT1000: remote 1000 metres, 9 stimulation levels and 3
modes, for 2 dogs.
Pro Trainer range:
•PT3000: remote 3000 metres, 18 stimulation levels and
8 modes, for 2 dogs.
•BEAGLE MASTER: remote 4000 metres,
18 stimulation levels and 6 modes, 4 dogs.
You can use as many "Finger Kick" as there are stimulation
buttonson the remote, i.e.:
•4 for the Pro Trainer (PT3000 and Beagle Master)
•2 for the TT1000

Functioning
The "Finger Kick"uses the remote as relay for long distance. So it
is important that the "Finger Kick"is in the remote's range, i.e.
less than 5 metres.
Sending
button
Strap,
velcro
Led,
light
flash

We advise you to place the remote in one of your pocket.
Caution, the range of the remote (distance remote-collar-receiver)
may be reduced if you place the remote in a bad place (at the
bottom of a bag, in the knee pocket,…)
Remark:
The body may act as a barrier to the wave spread between the
"Finger Kick" and the remote.
Range between the remote
and the collar
Max. 1000m (TT1000)
Max. 3000m (PT3000)
Max. 3000m (Beagle)
Rangebetween
the remoteand
theFinger Kick
Max 5m

Initialization
To use the "Finger Kick", it is important to link it with thebutton
of the remote.
Procedure:
1. On the remote, push simultaneously on the chosen button
and the programming button (central button for the
PT3000 and BEAGLE MASTER orlower button for the
TT1000).
2. Push until the LCD screen flickers.
3. Push more than one second on the button of the "Finger
Kick". CAUTION, you have to do that during about ten
seconds. In case of failure, begin again on step 1.
4. When the LCD screen stopsto flicker, the "Finger
Kick"is connected to the button of your remote.

Remark:
1. The collar-receiver has to be synchronized to the remote
to use the "Finger Kick"
2. The receiver must be on more than 50 cm of the remote
to ensure a good connexion between the two elements.
3. To connect the "Finger Kick" to another remote, you
must take away the previous remote from at least six
metres and begin again the initialization procedure.
Use
Push on the button of the "Finger Kick"as you do it to use the
remote. There is no button "on-off". When you push on the button,
you engage automatically the functioning.
From the last pushing, the system reacts instantaneously at every
touch. After ½ hour in stand-by, the react time is approximately of
one second.
After 4 hours in stand-by, you must reactivate the systemby
pushing on a touch of the transmitter.

Help
•When you push on the button, you must see a light flash
In case of no flash, the battery of a lifetime expected
from 7 to 10 years in normal use,is certainly out of
order. Please, return the device to your distributor.
•A light flash appears when you push on the button, but
nothing happens:
oInitialize the "Finger Kick" to the remote,
oInitialize a receiver to the remote (see remote
user's guide).
Technical caracteristics
Dimensions 27x30x17 mm
Weight 6 gr
WaterProof
Battery CR1025, 3V 30mAh
Frequency 2.4GHz
Power <1mW

CONFORMITY
All electronic dog training equipment designed and supplied by
Martin System has been subject toEuropean conformity tests.
Please consult local competent authorities before any use outside
the countries of the EU.
RECYCLING
The regulations state that all waste electrical and electronic
equipment must be recycled. If you have no further use for your
dog training equipment, or it is irreparable, you must not dispose
of it in the normal household waste, but return it to your dealer, or
if this is not possible, contact our customer services department for
further information.
Manufactured in accordance with the instructions of the
ECMA