MASCHIO GASPARDO PITAGORA User manual
1
PITAGORA
SQUARE BALER
ASSEMBLY INSTRUCTIONS
STANDARD EQUIPMENT
SPECIFICATIONS
Technical specifications
PITAGORA HIGHLIGHTS
2
FLYWHEEL & GEARBOX
DRAWBAR & QUICK
TRANSMISSION
STRONG STRUCTURE
AND IN-LINE DESIGN
PICK-UP SYSTEM CRANK FEEDER SYSTEM
TWINE BOX
SIDE CLAMPING
SYSTEM
KNOTTER SET
DESIGN
PITOGORA INLINE
GENERAL INFORMATION
Some parts of the PITAGORA IN-LINE have been removed for loading to the truck or container.
After each machine was disassembled, the parts were packed and loaded into the container.
Bolts, Washers and Nuts to be used during assembly are on the parts to be assembled. Do not mix
the bolts.
The assembly of the PITAGORA IN-LINE Baler is illustrated with pictures.
PLEASE FOLLOW THE SAFETY PRECAUTIONS DURING INSTALLATION, DISASSEMBLY AND
LOADING!
1. FRONT DRAWBAR
The drawbar will be mounted to the machine body from the indicated area.
8 X DIN933 M16X40 JAGGED BOLT
8 X DIN125 M12 WASHER
8 X DIN985 M12 NUT
1. FRONT DRAWBAR
Attach the jack to the perforated
pipe bearing on the front
drawbar and lock it with the pin.
1. FRONT DRAWBAR
2. HARROW
Assemble the harrow unit
with the fasteners as shown
in the right figure.
DIN933
M10x25
JAGGED BOLT
DIN125 M10
FLAT
WASHER DIN934
M10 NUT
BUSHING
2. HARROW
2 X DIN603 M10x35 SQUARE NECK BOLT
2 X DIN125 M10 FLAT WASHER
2 X DIN985 M10 FIBERED NUT
Mount this group to the area on the pick-up
unit with the fasteners.
2. HARROW
Assemble the harrow unit to the square holes
which are on the pick-up unit.
2. HARROW
Assemble the harrow unit by passing the
fasteners through the hole on the front
drawbar. Then install the spring.
Ø4 X143mm SPRING
2 X DIN94 Ø5X50mm COTTER PIN
Ø16 X197mm SHAFT
SPRING CONNECTION
POINT
3. PICK UP UNIT
Assemble the pick-up unit right and left casings through the
holes shown with the fasteners shown in the figure.
DIN603 M8x20
SQUARE
NECK BOLT DIN933 M8x20
JAGGED BOLT
3. PICK UP UNIT
Assemble the right and left wheels of the pick-up unit through
the holes shown with the fasteners shown in the figure.
Insert the shaft in the adjustment holes
in the appropriate position and pass the
suction pin.
Place the shaft in the hole by passing
the wheel through the slotted casing
sheet.
3. TAIL UNIT
Assemble the guard plate in the tail unit, side cover locking wedge plate, chains, tail back cover
plate as shown in the right figure.
3. TAIL UNIT
Assemble the ladder unit to the
area in the figure. Mount the fire extinguisher unit
to the area in the figure.
3. TAIL UNIT
Attach the lamp plate and stop lamps to the places shown in the figure and connect the electrical wiring.
4. REAR DRAWBAR
Mount the rear drawbar to the area in the figure above with bolted connections.
4. REAR DRAWBAR
Rear drawbar fasteners are as shown in the figure.
Table of contents
Other MASCHIO GASPARDO Farm Equipment manuals
