Massoth LGB 20410 User manual

Umbaubericht
Lokomotiven
LGB 2x410 RhB Tm 2/2 Tractor
Backfitting of a LGB “RhB Tm 2/2” Tractor wit a eMotion-S Soundmodule. Pict 1)
The loco already has a small onboard LGB Dekdoder. The original remains in the locomotive.
Pict-1: LGB 20410 : “RhB Tm 2/2”
Needed Parts:
1x 8222100 eMotion-S Soundmodule with Soundupdate 8222041)
1x 8241040 Speaker 40x40 mm
Screws to mount speaker
Stand 16.04.2020 Seite 1 / 4

Umbaubericht
Lokomotiven
Pict-2: Opening of the loco.
Backfitting:
•Remove the 6 marked screws at the bottom.
•Take first the open platform.
•Remove the cabin.
Pict-3: Installing speaker
•Remove the recessed side wall of the cab behind the bars.
•Mount the speaker with 4 Befestigen sie den Lautsprecher mit 4 screws M3) at the driving
panel.
Stand 16.04.2020 Seite 2 / 4

Umbaubericht
Lokomotiven
Pict-4: Connecting S-Decoder
•Program the S Decoder before mounting to the same address like the loco decoder.
•Solder the white + brown cable to the “Track+” and “Track-” of the motor connector.
•Remove the lower part of the decoder plate see marker) so that the speaker fits.
Pict-5: Mounting Decoder
•Mount the decoder in the driving panel.
•Plug the speaker cable to the decoder
•The speaker wire should not be in close to of the track cables because of possible
interference !
Stand 16.04.2020 Seite 3 / 4

Umbaubericht
Lokomotiven
Programming:
•Cause of the low resonance volume in the loco i raised up the volume : CV200=45.
•To bring the distinctive sound of switching to better advantage, I increased the delay : CV3
+ CV4 = 20
•Reduce the top speed of the decoder : CV5=160
•Check before assembling the sound and loco of correct function.
•Assembling the loco in reverse order.zusammenbauen.
Stand 16.04.2020 Seite 4 / 4